FLYSKY FS-BS6 Digital Proportional Radio Control System Instructions
- June 6, 2024
- Flysky
Table of Contents
Digital Proportional Radio Control System FS-BS6 FS-BS4
Receiver Overview
Status Indicator
The status indicator is used to indicate the power and working status of the
receiver.
- Off: The power is not connected.
- Lit in red: The receiver is on and working.
- Flashing quickly: The receiver is binding.
- Flashing slowly: The bound transmitter is off or signal is lost.
Connectors
Used to connect to the model and servos.
The FS-BS4 receiver has a gyroscope SVC function that can be used to improve
handling.
- CH1 to CH4: used to connect the servos, power, or other parts.
- BIND/VCC: used to connect the binding cable for binding, and the power cable during normal operation.
- SERVO: used to connect the i-Bus module and extend channels.
- SENS: used to connect all kinds of sensors.
Binding
- Insert the binding cable into the receiver BIND port;
- Plug the power cable into any other port, and the receiver’s LED will start to flash quickly indicating that it has entered bind mode.
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC ID：2A2UNBS400
Documents / Resources
|
FLYSKY FS-BS6 Digital Proportional Radio Control
System
[pdf] Instructions
BS400, 2A2UNBS400, FS-BS6, Digital Proportional Radio Control System, FS-BS6
Digital Proportional Radio Control System
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>