HIKVISION DS-PDMCK-EG2-WA Wireless Magnet Shock Detector User Guide

: June 6, 2024
: Hikvision

Table of Contents

APPEARANCE
ENROLLMENT
TEST
INSTALLATION
Specification
FCC Information
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DS-PDMCK-EG2-WA
Wireless Magnet Shock Detector
Quick Start Guide

50131-1:2006+A1:2009+A2:2017+A3:2020
50131-2-8:2016
50131-2-6:2008
50131-5-3:2017
Security Grade(SG)2
Environmental Class(EC) II
Certified by TUV Rheinland

APPEARANCE

Magnet
Positioning line
Indicator
Tamper Button
Power Switch
External Inputs
Battery
Shock Sensor

ENROLLMENT

TEST

Check if the installation position is properly.

I. Magnet Test
Magnet Detection Performance Table

Axes of Operation	Event	Without Nominal Distance	With Nominal Distance 5mm
Distance in Air	Distance in Air
X+	Remove	11	14
Approach	12	12
Remove	11	15
Approach	10	12
Y	Remove	35	30
Approach	28	23
Z+	Remove	48	46
Approach	40	38
Remove	41	38
Approach	32	30

II. Shock Test****

Sensitivity	Suggested scenarios
High	Concrete
Normal	Wood
Low	Window

III. Tilt Test
You can set the tilt angle (5° to 25°) in the mobile client software.
Note: The tilt detection is only applicable to horizontal or vertical scenes. The tilt angle is perpendicular to the geocentric direction as the reference standard.

INSTALLATION

I. Check signal strength and align the positioning line.
II. Detection Area for Different Material
a. Glass
b. Wood
c. Concrete
III. Install the detector.
(optional) route the cable through the cable hole if external inputs are required.

Note: Installation with sponge tape is not recommended if shock detection is enabled.

User Manual

Scan the QR code for more information and operation help.

http://enpinfodata.hikvision.com/analysisQR/showQR/d71b710e

Specification

Detection gap	According to the magnet detection performance table
External inputs	2
Shock detection	Yes
Tilt detection	Up to 25°
LED indicator	Green (MC), Orange (tilt), Red (shock), Blue (alarm)
Operating temperature	-10 °C to 55 °C (14 °F to 131 °F)

FCC Information

Please take attention that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

FCC Conditions

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.