FORMOVIE C015FGN-LITE Mini Projector User Guide
- June 6, 2024
- Formovie
Table of Contents
Mini Projector C015FGN-LITE
Quick Start Guide
Do not place any objects within 20 cm of the air vents.
Specifications
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.
Hereby, [Formovie (Chongqing) Innovative Technology Co., Ltd.] declares that
the radio equipment type [Mini Projector / C015FGN-Lite] is in compliance with
Directive 2014/53/EU and Radio Equipment Regulations 2017. The full text of
the declaration of conformity is available at the following internet address:
http://www.formovie.com/global/service/support/declaration.html
Wi-Fi 2.4G maximum transmitter power : 100mW at 2.4GHz – 2.4835GHz
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Important:
You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
RF Exposure Information:
The radiated output power of this device meets the limits of FCC radio
frequency exposure limits.This device should be operated with a minimum
separation distance of 20cm (8 inches) between the equipment and a person’s
body.
Battery Warning:
- Risk of explosion if the battery is replaced by an incorrect type.
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
HDMI
The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.
As with any bright light source, do not stare into the beam, RG2 IEC 62471-5:2015