Smart Communications Holding SJM2101 Tablet PC User Manual

Smart Communications Holding SJM2101 Tablet PC

All rights reserved.
Copyright © ….
No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form, by any means (electronic, photocopying, recording, or otherwise) without the prior written permission of the publisher.

Copyright protection claimed includes all forms and matters of copyrightable material and information allowed by statutory or judicial law or hereafter granted, including without limitation, material generated from the software programs which are displayed on the screen such as screen displays, menus, etc.

Products that are referred to in this document may be either trademarks and/or registered trademarks of the respective owners. The publisher and the author do not claim these trademarks.

While every precaution has been taken in the preparation of this document, the publisher and the author assume no responsibility for errors or omissions, or for damages resulting from the use of the information contained in this document or from the use of programs and source code that may accompany it. In no event shall the publisher and the author be liable for any loss of profit or any other commercial damage caused or alleged to have been caused directly or indirectly by this document.

Content subject to change without notice.

Introduction

Welcome to your SJM2101 Tablet PC.
To ensure the optimal performance of this product, please take the time to read this manual carefully.

Explanation of Advisements
In this manual we use three (3) levels of Advisements as follows:

• TheNotesymbolisusedfornotifyingtheuserofsomethingimportantorofsomethingthatneedsspecialattention.
• The Caution symbol is used to inform of something that could cause harm to, or malfunction of, thee equipment.
• TheWarning symbol is used to inform of something in which there is a conceivable risk of harm to the user if the Warning is ignored.

Symbols and Markings
This section provides information about the symbols that are used on the SJM2101, it is accessories or packaging.

or sold in the United States which certifies that the electromagnetic interference from the device is under limits approved by the Federal Communications Commission.

Exploring Your Device

Package Contents
In addition to the primary tablet unit, your product carton should contain all the below items.

SJM2101 Tablet PC Packing Contents

Tablet PC|

Device Layout

Front View

Indicator Light

| Indicator the camera on/off
---|---|---
3| Microphone| Recording sounds or for making voice louder
4| LCD| Display
5| Speaker hole|

Left-side View

Top View

Bottom View

Rear View

Managing Device Power

AC Adapter
The AC adapter accepts 5V, 2A DC Input.

Batteries
The SJM2101 device has one battery. If the SJM2101 device is not charged or powered up by the power supply, the SJM2101 device will shut down automatically. For more information, see Battery safety, page

Using the SJM2101

Power on for The First Time.

1. When starting for the first time, fully charge the device.
   Plug the power adapter into the device and charge the device to make sure that both batteries are full.

2. Boot.
   Press the power button to power on until the power LED is on.
   Do not press the power button repeatedly, and do not press and hold the power key for more than 4 seconds.

3. Enter/exit sleep mode.
   When the device opens the Android system, press the power key shortly to see the screen turned off. The power LED will flash, indicating that the system is in the sleep mode.
   When the device enters sleep mode, press the power-on key to see the screen lit. When the power led is solid, the system has exited sleep mode and entered normal operating mode.

4. Shutdown/Reboot.
   Short press power button to shut down or reboot the device.

Use WIFI
Wifi is default set to be off.

Use Bluetooth.
BT is default set to be off.

Precautions for the safe use of the product.

Before using the SJM2101 device, please read this manual and precautions carefully. Otherwise some unforeseen consequences can occur. The operating environment temperature of the equipment should not exceed 40℃

Battery safety
The battery working environment temperature is 0℃ to 40℃. Please do not use the battery in an environment exceeding this temperature range.

1. Improper replacement of the battery is dangerous. If needed, use the battery recommended by the manufacturer.
2. The battery charging temperature range is 0℃ to 45℃. Please do not charge the battery outside this ambient temperature range.
3. When using battery power in an extremely low temperature environment, you may experience shortened operating time and incorrect battery level reading. This phenomenon comes from the chemical characteristics of batteries. The appropriate operating temperature for the battery is 0 °C ~ 40 °C
4. Do not leave the battery pack in storage for more than six months without recharging it.
5. Recharge the battery pack when it is nearly discharged. When recharging, make sure that the battery pack is fully charged. Doing so may avoid harm to the battery pack.

Charging safety
When charging the device, please place the device in a normal room. The recommended device charging environment temperature range is 0℃ to 40℃.

Wi-Fi is secure
Turn off Wi-Fi features when Wi-Fi is prohibited, such as during an airplane flight.

Care and maintenance
When wearing headphones, excessive volume can cause hearing loss and even damage to heari

Troubleshooting

In most cases, restarting your device will cure any problem. If your device has crashed, hold down the power button for 8 seconds to hard shutdown. Press it again to turn it back on.
If this does not fix the problem, contact your supplier.
Please have your serial number ready. This can be found on the back of your device.

Appendix A Compliance Information

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

Modifications not expressly approved by Device Manufacturer could void the user’s authority to operate the equipment under FCC rules.

Part 15B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. Modifications not expressly approved by Device Manufacturer could void the user’s authority to operate the equipment under FCC rules.

FCC RF Radiation Exposure and SAR Statements
The device has been tested for body-worn Specific Absorption Rate (SAR)compliance. The FCC has established detailed SAR requirements and has established that these requirements. RF Exposure Information The radio module has been evaluated under FCC Bulletin C95.1 and IEEE 1528 and found to be compliant to RF Exposure from radio frequency devices.
This device meets the applicable government requirements for exposure to radio frequency waves. The highest reported SAR level for usage near the body (0mm) is 0.92 W/kg.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>