TOPGREENER TGTSNL Wireless Motion Sensor LED Toilet Light Instruction Manual

: June 3, 2024
: Topgreener

Table of Contents

FEATURES
SPECIFICATIONS
INSTALLATION
SETTINGS/ OPERATING
WARRANTY
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

INSTALLATION INSTRUCTIONS

Model: TGTSNL
Wireless Motion Sensor LED Toilet Light

FEATURES

19 Colors to choose from
2 Light modes: cycle mode, select mode
6 Light levels
Daylight sensor
PIR motion sensor: detection range 170°
Waterproof LED

SPECIFICATIONS

Batteries Required………………………………………………………..3 AA (not included)
Operating Temperature……………………………………….. -4 to 140°F (-20 to 60°C)
Device Dimension……………………………………………… 3.15”W x 3.30”H x 0.89”D

INSTALLATION

Slide battery cover off the back of the device and insert 3 AA batteries as marked in the battery compartment.
Lift toilet seat
Hang the Toilet Light on the rim of the toilet bowl and bend the flexible arm to fit the rim Model: TGTSNL Wireless Motion Sensor LED Toilet Light

SETTINGS/ OPERATING

Defaults:

When batteries are installed, the device should already be ON.
The default mode is cycle mode. The LED light will cycle through 19 different colors when motion is detected in the dark

Turning device on/off:

To turn the device on or off, hold down the selection button for more than 5 seconds until the red light flashes

Switching the light mode between cycle and selective:
NOTE: Green blinking light indicates you’re in cycle mode, Blue blinking light indicates you’re in selective mode

From the default mode, press and hold the button for 5 seconds and release the button immediately when the LED light blinks blue 4 times.
- Then immediately choose your color by pressing the button and releasing it until the color desired appears (19 colors avail.)
- Once the color comes up, stop and wait 7 seconds. When the LED blinks once, that indicates that your selection has been successfully accepted
To change back to color cycling mode, hold down the button for 5 seconds and release the button immediately when the LED light blinks green 4 times.
- Wait about 7 seconds and the LED will blink once to indicate that color cycle mode has been successfully selected

NOTE: If you hold the button down and the green light comes on, that means you’re in color cycle mode. Just hold down the button for another 5 seconds until the blue light comes on and you will be in selective mode.
If you get red blinking lights, that means you’ve held the button too long and the device turned off.

Changing the brightness of the LED:
There are 6 preset brightness levels
• Press and release the button to cycle through those brightness levels (This is best to test in low light or in the dark)

NOTE: The PIR sensor will automatically turn the LED light on when motion is detected in the dark. The daylight sensor will prevent the LED from turning on when there is enough ambient light in the room

WARRANTY

This device is warranted to be free of material and workmanship defects for 1 year from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Top Greener, Inc. Warranties from other Top Greener products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Top Greener shall not be liable to the purchaser or end user customer of Top Greener products for direct, indirect, incidental, or consequential damages even if Top Greener has been advised of the possibility of such damages. Top Greener’ total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory