tuya LVD-06 Smart Door Lock with Apartment Management System User Manual
- June 6, 2024
- Tuya
Table of Contents
tuya LVD-06 Smart Door Lock with Apartment Management System User Manual
Product Introduction
This smart lock is a new type of intelligent door lock . It has 4 core patents
and can be used in most languages worldwide. Currently, Tuya Smart App can be
downloaded and applied in 159 countries and regions. Advanced electronic and
biometric technology enables the smart lock to have intelligent recognition
capabilities, making users’ work and life easier and more convenient.
This smart lock can be used for private homes, commercial offices, residential
buildings and more.
Please read this manual carefully before using this product.
Download Tuya Smart App
Add Lock
Dynamic Passcode
Slide your finger on the phone screen on the main interface, as shown in Figure A, and then click “Get dynamic code” to get dynamic passcode. You can copy the passcode, which expires after 5 minutes.
Add Unlock Modes
In main interface, select member management, and select user, and then select to add door card, fingerprint, and passcode.
For example: add fingerprint Select “finger” function, and then click “+” , and then click “Start collecting” to start inputting fingerprint. After capture fingerprint 4 times, fingerpint is added successfully .
Add Member
Family: The user will enter the family group. And this user will be able to control and use all products in the family group.
Others: The user only appears in the member list of the current door lock and only can perform open lock functions.
Select “Others”, the permission and the valid period of users can be set. And to grant the user permission to operate the door lock, use the sharing function.
Passage Mode
Short press button and passage mode is activated. In passage mode, everyone can directly unlock the door without any access permission. Passage mode can be turned off by short pressing button again.
Secure Lock Mode
Initialization by App
Confirm that the lock to be deleted is online, select the lock and hold for a while, and then click to “Remove Device”, and click “Confirm” to delete and initialize the lock.
(Note: If the lock is offline, you need to slide your finger on the phone screen on the main interface to make the lock online.)
Initialization by Handle and Secure Lock Button
Turn Rear Handle left or right, and then push secure lock button, and hold for 10 seconds, accompanied by a continuous beep. After the lock is initialized, all fingerprints, passcodes, IC cards are deleted from lock.
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.