TPI 312C Pocket Digital Thermometer Instructions
- June 6, 2024
- TPI
Table of Contents
TPI 312C Pocket Digital Thermometer Instructions
Instruction
To measure Temperature with this unit follow these simple instructions:
Select either the Fahrenheit or Celsius mode:
With the unit “off” press and continue to hold the ON/OFF button. The LCD will alternate between °F and °C. Release the ON/OFF button when desired measure- ment mode appears on the LCD.
Remove the protective sheath from the stem. Press the ON /OFF button. Insert stem into area or object to be tested. At least 1/2″ of the stem must be inserted.
Auto Field Calibration
- Fill a container with crushed ice and add clean water to a depth of 4 inches. Stir the ice and water for 2 to 3 minutes.
- Insert at least one inch of the stain less steel shaft of the thermometer into the ice bath. Allow the reading on the ther mome ter to stabilize. The temperature reading must be within ±2° of 32°F or t1° of 0°C for calibration to have effect.
- Press and hold the D-H/CAL button for approximately 8 seconds until “CAL” is displayed. The thermometer will return to normal operation.Calibration is complete.
WARNING: The stem is a sharp and point-ed object which can be dangerous.
The Data hold function is used by pressing the D-H button when taking a measurement. The measurement will flash in the LCD when Data Hold is in use. To return to normal function, press and release the D-H button a second time.
Press the ON/OFF button to end operation, or the unit will automatically power off after 35 minutes.
Specifications
Range. ———————- -58° to 300 °F/-50°to 150 °C
Resolution ———————- 0.1 °F/°C
Accuracy ———————- +/- 2°F/ +/- 1°C
Sampling Time —————— 1.5 seconds
Battery ———————- 1.5 Volt Button
THIS INSTRUMENT is in compliance with
EN 61326-1: 2013
EN 61000-3-2: 2014
EN 61326-2-2: 2013
EN 61000-3-3: 2013
Test Products International, Inc. Beaverton, OR 97005 5
03-520-9197 Fax: 503-520-1225
www.testproductsintl.com
email: [email protected]
Made in S.Korea