pivo PVP1L01 Pod Lite User Guide
- June 6, 2024
- Pivo
Table of Contents
Pod overview
| 1. Panoramic Mount | 5. LED indicator |
|---|---|
| 2. Grip fastener | 6. Power button |
| 3. Bubble level | 7. Extendable legs |
| 4. Micro USB charging port | 8. 1/4” UN thread |
Charging the Pod
LED indicator status
| Power off | Blinking red |
|---|---|
| Power on / Ready for smartphone pairing | Blinking blue |
| Connected to smartphone | Blue |
| Charging | Red |
| Fully charged | No light |
| Low battery / Not charged | Blinking red |
| Pairing Remote Contro | Blinking white |
Downloading the Pivo Pod App
Creating a Pivo account
-
Open the Pivo Pod App and tap “Yes, I have Pivo”
-
Create a Pivo Account using a valid email address
– Tap “Create account” under the “Log in” button
– Fill out the “Sign up” form
– Confi rm your registration by email -
Go back to the Pivo Pod App and “ Log in” to your new account
– Tap “Allow” to enable access to the microphone, photo album and voice recognition
Pairing your smartphone
- Turn your smartphone on and enable Bluetooth
- Press and hold the power button until it beeps
- In the app, tap “Connect” and follow the instructions on the screen to fi finish the pairing process
Positioning your smartphone
- Place your smartphone onto the Panoramic Mount
- Tighten the grip fastener to secure your smartphone
- For detailed instructions on how to use each mode, visit help.getpivo.com
[ For Australian customers ]
Our goods come with guarantees that cannot be excluded under the ACL. You are
entitled to a replacement or refund for a major failure and for compensation
for any other reasonably foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if goods fail to be of acceptable quality
and the failure does not amount to a major failure.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20 cm the radiator
your body. This device and its antenna(s) must not be co-located or operation
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>