HEADRUSH HRB 3038 True Wireless Earbuds Instruction Manual

HEADRUSH HRB 3038 True Wireless Earbuds

INTRODUCTION

Thank you for purchasing the HRB 3038 true wireless earbuds. In order to maximize your listening experience please read the following instructions.

1. LED indicator
2. Multi-function button (MFB)
3. Microphone
4. Charginc case LEDs
5. USB-C port

Additional large and small earbud tips included (medium tips installed on earbuds).

OPERATING INSTRUCTIONS

Prior to first use, remove the plastic battery isolator tab located between the earbuds and the charging case. NOTE: The function compatibility may vary among different smartphones or devices. Not all functions are available on all devices.

CHARGING THE CASE

Use the included charging cable to fully charge the case before first use. It will take approximately 2.5 hours to fully charge.

• LED flashing, the power level is less than 25%
• LED ON and 1 LED flashing, the power level is less than 50%
• LEDs ON and 1 LED flashing, the power level is less than 75% “3 charge to 4
• LEDs ON, the battery is fully charged

CHARGING THE EARBUDS
Place both earbuds in the charging case, they will automatically begin charging and the red LED on the earbuds will turn ON. When the earbuds have fully charged, the LED will turn OFF. It will take approximately 1.5 hours to fully

PAIRING

The earbuds will automatically enter Bluet ooth” pairing mode when used for the first time. The left and right earbuds will automatically connect to each other.

1. Remove both earbuds from the charging
2. Select “HRB 3038” on the Bluetooth• device list to pair the earbuds automatically.
3. When the earbuds have successfully paired the red LEDs will flash on BOTH SIDE after 5 sec
4. After init ial pairing, the earbuds will automatically turn ON and connect to your device when removed from tlie charging case, provided both earbuds and your Bluetooth” are ON and within range.
5. If the earbuds are not connected to a Bluetooth” device, they will turn OFF after 5 minutes.

TO USE ONLY THE LEFT OR RIGHT EARBUD
If both earbuds are t urned ON and paired to your Bluetooth”device, you can return the right or left earbud to the charging case and the earbud (R or L) in your ear will continue t o play. To use the right or left earbud only, remove it from the charging case. It will turn ON and connect automatically to your Bluetooth” device.

RESET
If the left and right earbuds do not connect to each other, you will need to reset the earbuds and clear paired memory.

1. Remove “HRB 3038n from your devif.:e listing and turn Bluetooth•
2. Then press and hold either MFB button firmly in t he center for 10 seconds to enter reset mode.
3. The red LED will Aash 3 times. Release t he button, the earbuds will beep. Return the earbuds to the case.
4. Turn Bluetoot h’ back ON in your device settings and select “HRB 3038” .

OPERATION

• While playing music, press again to resume press either MFB button to pause, press
  and hold t he left MFB for t he previous song

• The music will pause and the earbuds will ring when t here is an incoming call. Press either MFB button once to answer the call, press and hold to reject the cal l. Press again to end a call To disconnect from your device while still wearing both earbuds and you are not listening to music or having a phone conversation:

• Enter the Bluetooth• settings in your paired device, select “HRB 3038” and disconnect

• The earbuds can also be turned OFF by pressing and holding either MFB button for approximately 5 seconds. The earbuds can be turned ON again by pressing and holding both MFB buttons for approximately 3 seconds

WARNING!

Supervise children when using equipment
This product is not a toy

• Listening to earbuds at high volume levels, particularly over extended periods of time may damage your hearing
• If you have a pacemaker or other elect rical medical devices, you should consult your physician before using this product
• The operation of switching on your Hi-Fi system or plugging in t he earbuds may cause clicks which at high volume setting may affect yo”‘r hearing. Therefore, always set the vol.,.me control to minimum before switching between different sources (tuner, t urntable, CD player, et c.) or plugging in the earbuds
• DO NOT use earbuds while driving or cycling
• The small parts included with t his product can be a choking hazard. This product is not intended for use by small children and should be kept away from children under 3 years of age
• If not used for long periods, it is recommended to charge the earbuds and case at least every 3 months
• Please dispose of rechargeable batteries properly. DO NOT dispose of batteries in fire t o prevent an explosion

TROUBLESHOOTING

• No sound
  Please check t he volume on your audio device to make sure it is outputting sound

• Connection Problems

  • Please press both MFB buttons 3 times to reset both earbuds when
    there is a problem with rws or Bluetooth• connection.

  • Refer to the cleared paired memory and reset section

• The earbuds are not fitting comfortably
  Please switch out the earbud tips to a different size to find the appropriate fit Ensure t he left and right earbuds are in the correct ear

• Improving the Sound
  Sound can sometimes be improved by moving to a lerger e.irtip size. The eartips still need to fit comfortably in your ear

CLEANING
Your earbuds may require periodic d eaning. Remove the t ips from the earbuds and wash them with a mild detergent and water. Make sure the t ips are dry before putting them back on the earbuds.

IMPORTANT SAFETY INFORMATION

CAUTIONS

• Keep in a safe place free from dust, liquid and ext reme temperatures
• DO NOT attempt to disassemble the product
• DO NOT use chemicals to clean the product

SPECIFICATIONS

This device complies with Industry Canada license-exempt RSS standards(s)_ Operation is Subject to the following two conditions:

• This device may not cause interference .and this device must accept any interference including interference that may cause undesired operation of the device
• This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus sat out in t h& Radio lntarfer&nc,; R&gulations o-f industry Canada
• This digital apparaws does not exceed the Class B limit For radio noise emission from digital apparatus sat out in t ha Radio interference., Regulations of Industry Canada.

IC STATEMENT
This device meets the exemption from the routine evaluation limits in section 2.6 of ~SS 102 and compliance with RSS 102 RF exposul”& users cal”I obtain CanBidian information on RF exposune and compliance.
RF EXPOSURE STATEMENT
xposufa requirement. Tile deviat can be used in portable exposure condition without restriction.

REGULATOlfY COMPLIANCE
Thi• device contains llcenca-exempt transmitters t ha1 comply with Innovation, Selene& and
Economic Developmant Canada’s licence-exempt RSS(s). Operation Is suoject to the following
t wo conditions:

1. Thfs device may not cause lnterferene&
2. Thfs device must aCC&pt any lnt&rf&r&nce, Including lnt erferene& that may cause und95lred operation of the device This equipment complies with IC RSS-102 radiation exposure llmlu set forth for an uncontrolled environment.

CAN ICES-003{Bl/NMl!.003(B)

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• nnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
2. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
3. cience and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: his device may not cause interference.
4. This device must accept any interference, including interference that may cause undesired operation of the device

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>