tomons LP01008 Desk Lamp Instruction Manual
- June 6, 2024
- tomons
Table of Contents
tomons LP01008 Desk Lamp
Product Instruction
Package list
Desk lamp x 1
Power Adapter x 1
Instruction Manual x 1
Parameters
Product model: LP0l 00BInput voltage: 100-240V- 50/60Hz
Rated power: 12W (60XQ_2W LED module)
Light output waveform frequency>3125Hz
Blue light hazard category RGO
Power factor: 0.5
Features
- Switch : Short touch to turn on/off the lamp.
- Brightness Decrease: Short touch to decrease brightness; long touch to decrease brightness in stepless way.
- Brightness increase: Short touch to increase brightness, long touch to increase brightness in stepless way.
- Reading mode: Long touch the icon until the light flashes once to set a 45-minute countdown timer. Long touch the icon again until the light flashes twice to cancel the timer. Under the reading mode 6 types of brightness are available (10%, 20%, 40%, 60%, 80%, 100%).
- Leisure mode: Long touch the icon until the light flashes once to set a 45-minute countdown timer. Long touch the icon again until the light flashes twice to cancel the timer. Under the leisure mode 6 types of brightness are available (10%, 20%, 40%, 60%, 80%, 100%).
- Working mode: Long touch the icon until the light flashes once to set a 45-minute countdown timer. Long touch the icon again until the light flashes twice to cancel the timer. Under the working mode 6 types of brightness are available (10%, 20%, 40%, 60%, 80%, 100%).
| Reading Mode| Leisure Mode| Working Mode l
---|---|---|---
Color Temperature| 3000K| 4000K| 6500K
Color Rendering Index| 90| 90| 90
Wireless Charging
How to use
Connect the adapter to the desk lamp, and make sure that there are no magnetic objects around before connecting the power supply. Place the desk lamp on a flat place to keep the phone from slipping off. Place the mobile phone on the wireless charging base to charge. Note that the thickness of the mobile phone case should not exceed 5mm.
Precautions
To use wireless charging, the phone must support the wireless charging
function. If the phone case is too thick, the charging effect may be affected.
It is recommended to remove the phone case when using wireless charging.
Do not expose the phone to direct sunlight, high temperature, or humidity when
it is being charged.
Warning: Please check the working voltage before use the lamp. Unmatched voltage may damage the lamp and bring safety hazards.
- This lamp is for indoor use only. Please place it steadily on a flat surface.
- When working, the lamp holder may become hot gradually. Please keep the surrounding air circulating. Do not cover the lamp holder to facilitate heat dissipation.
- The light source of this product is not replaceable. When the light source reaches its lifespan, do not disassemble the lamp privately.
- If the power cable of the lamp is damaged, you should replace it by contacting the manufacturer to avoid danger.
Reminder
- Using unapproved or incompatible power supplies may cause fire, explosion, or other hazards.
- This product and its accessories contain some small parts. Please keep the product and its accessories out of the reach of children to prevent children from unintentionally damaging the product and accessories or swallowing small parts that may cause breathing difficulty or other hazards.
- Please use this product within the temperature range of-5~ 40° C. When the ambient temperature is too high or too low, it may not work.
- Keep the lamp away from liquid and moisture to avoid possible damage.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Exposure: A distance of 15 cm shall be maintained between the antenna and users, and the transmitter may not be co‐located with any other transmitter or antenna
Contact Information
USA
Tel:+ 1 909-698-7018
Phone hours: Weekdays 9 AM to 5 PM (EST)
Email: support@inateck.com
Web: www.tomons.com
Addr: lnateck Technology Inc, 2078 Francis St., Unit 14-02, Ontario, San
Bernardino, CA 91761
Germany
Tel: +49 341-51998410 Fax: +49 34151998413
Phone hours: Weekdays 9 AM-5 PM (CET)
Email: support@inateck.com
Web: http://www.tomons.de
Addr: F&M Technology GmbH, Fraunhoferstra8e 7, 04178 Leipzig
Japan
Email: support@inateck.com
Web: www.tomons.com
Company of License Holder
F&M Technology GmbH
Fraunhoferstra8e 7,04178 Leipzig
Tel: +49 341-51998410
Manufacturer Information
Shenzhen LiCheng Technology Co., Ltd.
Add: Rm. 2507, Bldg. 11, TianAn Cloud Park, Bantian Street,
Longgang District, Shenzhen, Guangdong, China
Tel: +86 755-23484029
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>