NEW BRIGHT 61288 4×4 Ram TRX Radio Control Trucks Owner’s Manual
- June 6, 2024
- NEW BRIGHT
Table of Contents
OWNER’S MANUAL
Please read and understand all precautions prior to use.
Thank you for choosing a premium New Bright product.
Note.
The vehicle has working lights. When driving forward or reverse the lights
will turn on. When stopping either in forward or reverse the lights will turn
off.
This transmitter is equipped with 2.4GHz technology which allows up to 6
vehicles to be raced at the same time.
The transmitter will automatically sync with the vehicle.
Support
Trouble Shooting
Problem – Vehicle does not move or move slowly.
– Make certain there are fresh alkaline batteries in the transmitter and that
they have been installed in the correct position.
– Are the (+) and (—) markings on the alkaline batteries in the same position
as the (+) and (—) markings in the Transmitter Battery Compartment?
– Are the metal contact tabs touching, rusty or dirty in the transmitter?
– Has the vehicle been fully charged?
– Make certain that the vehicle ON/OFF switch is in the “ON” position.
Problem – Vehicle moves by itself or exhibits reduced range from the
transmitter.
– Make certain there is no outside radio interference in your area. The best
way to test this is to take the vehicle as far away from radio towers,
electrical lines, or tall buildings as possible to ensure no further radio
interference will occur.
Support
Cautions
Always remove batteries from the transmitter when not in use.
Do not dispose of batteries in a fire. Leakage, explosion, and personal injury
may occur.
Do not attempt jumps or tricks with this vehicle.
Do not attempt to remove the internal battery.
Do not use included USB cord for anything other than its intended purpose.
Always keep a USB cord stored when not in use. Adult supervision is
recommended.
F.C.C. CAUTION:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to rack communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver.
– Conned the equipment into an outlet on a circuit different from [ha! to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Section 1: Table of Contents
Section 2: Component Checklist
Section 3: Vehicle Features and Functions
Section 4: Vehicle Features and Functions
Section 5: USB Smart Charge Technology Charging the Vehicle
Section 6: Transmitter Battery Installation
Section 7: Transmitter Features and Functions
Section 8: Proper Use Precautions and Care
Section 9: Trouble Shooting
Section 10: Cautions
Section 11: Warranty Information
- (1) R/C Vehicle With USB Cord
- (1) Transmitter
- (2) AA Batterie
- If the vehicle pulls to the left or right during forward driving the Wheel Alignment may need to be adjusted. The Wheel Alignment Dial is located on bottom of the chassis between the front wheels.
Battery
USB Smart Charge Technology
This product is equipped with USB Smart Charge Technology. The built-in “smart
chip” can recognize the power output level of your chosen USB charging device.
Charge times will vary between charging devices. Charging from a wall outlet
with a USB adapter may be faster than charging from a USB port on a computer.
Using Advanced USB Power Delivery, the smart chip will charge the vehicle’s
internal battery at the fastest speed allowed by your charging device.
Charging the Vehicle
This vehicle is equipped with an internal Lithium-Ion battery that is
recharged via USB.
ON; OFF Switch must be in the OFF position prior to charging.
- Locate the ON/OFF switch and USB cord on the underside of the vehicle.
- Turn the ON/OFF switch to the “OFF” position.
- Slide open Storage Compartment cover.
- Remove USB cable from the Storage Compartment. (Use care when extending the cord as it is attached to the inside internal battery). The cord can be plugged into any computer or USB outlet adapter (not included).
Transmitter
Battery Installation
- Press and slide in the direction of the arrow open battery compartment cover.
- Insert 2 “AA” size batteries. Make sure the positive (+) and negative (—) markings on the batteries match the markings inside the Battery Compartment.
- Replace the Battery Compartment Cover making certain that the Compartment tab has “snapped” into the locked position.
New Bright
Warranty Information
USA & Canada 30-Day
Limited Warranty
New Bright Industries warrants to the original purchaser that this product will be free of defects in materials and workmanship for thirty (30) days from the date of purchase. In the event of such a defect within the warranty period, New Bright will repair or replace the product at our sole discretion. This warranty does not cover damage resulting from unauthorized modifications, accidents, misuse, or abuse.
Should your item have a defect covered under this warranty, first call the toll-free number listed below? Most problems can be resolved in this mariner. If necessary, you will be issued a Return Authorization number (RA) and instructions on how to obtain a Product Return Form. The Product Return Form is to be used when returning a product to us (postage pre-paid and insured by the consumer).
When returning a defective product, please package the product, the Product Return Form, and a copy of the dated sales receipt as proof of purchase. Be sure to mark the RA number on the Product Return Form. If the product is returned without a dated sales receipt, it will be excluded from coverage under this warranty. Please allow 4 to 6 weeks for delivery of repaired or replacement vehicles (depending on your location).
New Bright Industries’ liability for defects in materials and workmanship under this warranty shall be limited to repair or replacement at our sole discretion. In no event shall we be responsible for incidental, consequential or contingent damages (except in those states that do not allow this exclusion or limitation).
Valid only in the USA & Canada.
Contact New Bright Industries Customer Service Toll-Free at:
1-877-NBI-TOYS
(1-877-624-8697)
Monday through Friday, 8:00 AM to 5:00 PM Eastern Time
U.S. Toy Sales and Marketing Co. Inc.
30260 Oak Creek Drive — 2nd Floor
Wixom MI
48393 1-877-624-8697
http://www.newbright.com/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>