edishine HSPL01A LED Knuckle Bullet Spot Light Instruction Manual
- June 6, 2024
- edishine
Table of Contents
LED Knuckle Bullet Spot Light
SKU: HSPL01A
[Instruction Manual]
Thank you for your purchase.
Please contact us if you have any questions.
We will get back to you within 24 hours. Please attach your Order ID
so that
we can serve you better. V210813
WARNING: PROPOSITION 65
Handling the coated electrical wires of this product can expose you to
chemicals including lead, which is known to the State of California to cause
cancer and/or birth defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov.
WARNING
Read all of these installation instructions before installing the fixture.
These products may represent a possible shock or fire hazard if improperly
installed or attached in any way. Products should be installed by a qualified
electrician in accordance with these instructions, the current local
electrical code, or the current National Electric Code (NEC).
- This product must be installed by a person familiar with the construction and operation of the product and the hazards involved and in accordance with current electrical codes and/or the current National Electric Code (NEC).
- To reduce the possibility of electric shock, fixtures must be grounded.
- Do not attempt to open the LED light engine.
- Do not look directly into fixtures.
- The lamps must be used within the specified voltage range;
INSTRUCTIONS
- Before installation, please cut off the power.
- Remove old fixtures if necessary for installation.
- Connect line voltage (hot) AC supply wire(s) (Black) to the line voltage AC wire(s) (Black) inside the canopy via the wire connector.
- Connect neutral (common) AC supply wire(s) (White) to the neutral AC wire(s) (White) inside the canopy via the wire connector.
- Connect the grounded AC supply wire(s) [Green or bare wire(s)] to the grounded AC wire(s) [bare copper wire(s)] using the wire connector.
- Cap and insulate all unused leads.
- To aim the light, loosen the side bolt connected to the knuckle arm to aim the fixture up or down. Re-tighten the bolt to secure the fixture in the desired position.
- To prevent rain, use silicone caulk to caulk the top and sides of the canopy and aiming arm.
CARE AND MAINTENANCE
Periodically clean the fixture and diffuser using a mild, non-abrasive cleaner and soft cloth. When cleaning the fixture, make sure the power is turned off. Do not spray cleaner directly onto any part of the fixture or LEDs.
Photocell Specifications
– Turn-On Light Levels: 10-16Lux
– Turn-Off Light Levels: <65Lux
– ON/OFF Ration: 1: 5
– Time Delay: 30-180 Seconds; (To avoid the influence of other light sources,
a delay of 30s-180s set when the fixture is turned off).
Specifications
– Input Voltage: 120-277VAC，50/60Hz
– Color Temp: 3000K
– Power Rating: 22W
– Luminance: 2832lm
– Surge Protection: 4KV
– CRI: 85+
– Life Span: 60000 hours
Package Includes
– LED Knuckle Bullet Spot Light x 1
– Instruction Manual x 1
– Sponge Gasket x 1
– Wire Connector x 3
– Screw x 4 ****
One Year Limited Warranty
MEDICINE warrants this product to be free from defects in material and workmanship for a period of one year from the date of purchase. Warranty is void if the damage is caused by misuse or improper installation. Our dedicated customer service team will get back to you within 24 hours.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>