edishine HGSL10A LED Spot Light Instruction Manual
- June 5, 2024
- edishine
Table of Contents
edishine HGSL10A LED Spot Light
Product Layout
Installation
WARNING :Never push the fixture into the ground by the lamp body (A) or use a hammer to insert the ground stake (C) into the ground.
Installing the light
- Prepare a hole in the installation location. Use a tool such as a screwdriver (sold separately) to prepare the installation hole to ensure the hole is not larger than the ground stake (C).
- Install the fixture in the ground by pushing on the foot step (1) on the ground stake (C). Do not push on the lamp body (A).
- The lamp body (A) can rotate up and down 90 degrees.
Connecting the power
After the fixture is installed, insert the plug (D) into an outlet
Adjusting the illumination, brightness output of the light
- Choose your preferred lumen output from two options: High light or Low light.
- The light cycles from High light (552lm) → OFF → Low light (398lm) → OFF → High light (552lm) → OFF → Low light (398lm) , etc.
- Push the switch (B) to cycle through the above selections.
Troubleshooting
Problem
The fixture will not light There is no power Ensure the Plugged into the GFCI
wall outlet Ensure that a bresker or GFCI circuit has not been tripped
Care and Cleaning
- Clean the fixture with a soft dry cloth.
- Do not use any cleaners with chemicals, solvents or harsh abrasives.
Specifications
- Input Voltage：120VAC，60Hz
- Power Rating: 5.15W (398lm) 7.84W (552lm)
- Luminance: 398lm (5.15W) 552lm (7.84W)
- Color Temperature：3000K
- Life span: 50000 hours
- CRI: 80+
- Warranty: 1 years
One Year Limited Warranty
EDISHINE warrants this product to be free from defects in material and workmanship for a period of one year from the date of purchase. Warranty is void if damage is caused by misuse or improper installation. Our dedicated customer service team will get back to you within 24 hours