maytronics Dolphin Trident Robotic Pool Cleaner User Guide
- June 6, 2024
- maytronics
Table of Contents
maytronics Dolphin Trident Robotic Pool Cleaner User Guide
Thank you for purchasing a Maytronics Robotic Pool Cleaner.
The Robotic Pool Cleaners by Maytronics deliver advanced clearing technology’s. long lasting performance and easy maintenance. You and your family will be free to enjoy swimming with full confidence that your pool is completely clean.
Cautions and Warning
- Use the originally supplied power supply only.
- Do not use an extension cable in any case whatsoever.
- Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth leakage interrupter.
- Keep the power supply out of standing water.
- Do not enter the pool while the Pool Cleaner is working.
- Unplug the power supply before servicing.
- Do not pull the Pool cleaner from the pool using the cable.
- Use the Pool Cleaner in the following water conditions only: Chlorine Max 4 ppm; pH 7.0 – 7.8; Temperature 6 -34°C (43-93°F); NaCI Maximum = 5000 ppm.
- Specifications:
Motor protection : IP 68
Minimum depth : 0.80m/2.6ft
Maximum depth : 5m/16.4ft
Helpful Hint
- When working, the Power Supply should be placed in the shade.
- If the Dolphin is fitted with combined or wonder brushes, gently squeeze the brushes until they are soaked with water.
- Release minimal required floating cable length to ensure proper pool coverage. Leave excess cable rolled outside the pool.
- After each cleaning cycle wash the filter bag or cartridge. Clogged filter bags reduce scanning and cleaning efficiency.
- Once a week unplug the cable from the power supply, unwind the tangled portions of the cable, straighten it out and leave it in the sun for several hours.
- Store the pool cleaner in a shady place on its Caddy, if not on a caddy, place the pool cleaner upside down.
Robot Operation
Set up
Position the power supply at least 3m /10ft away from the edge of the pool.
Change the handle position to diagonal. This will determine the speed at which
the robot advances along the waterline.
Into the pool
Operation
The robot will now begin working for a complete cleaning cycle. At the end of
the cycle, it will automatically switch itself off.
Out of the pool
Cleaning the filter
Periodical maintenance
Storage
Coil the cable and store in a cool, dry place on the Caddy. Do NOT store the robot where it will be exposed to direct sunlight, excessive heat or to frost.
Caddy Assembly
Warranty registration
For online product warranty registration: registration.maytronics.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>