STECH 53804-DI Tripod Selfie Stick with Light User Manual

: June 6, 2024
: STECH

Table of Contents

Documents / Resources
Read User Manual Online (PDF format)
Download This Manual (PDF format)

53804-DI Tripod Selfie Stick with Light
User Manual
STECH 53804 DI Tripod Selfie Stick with Light

DESCRIPTION

STECH 53804 DI Tripod Selfie Stick with Light -
DESCRIPTION

Built-in Rechargeable Light
270º Rotating Phone Clamp
Detachable Remote
Handle Converts to Tripod

PAIRING THE WIRELESS SHUTTER
TO YOUR PHONE

Pull to remove the clear plastic tab from the wireless remote to activate the internal battery.
Hold down and press the remote button to power on and the LED indicator will flash blue.
Search and pair with BT name “Selfie Stick” on your cellphone. The LED indicator will stop flashing after it is successfully connected.
Use the remote control to take pictures from your phone when you are using the tripod.
The remote control will automatically shut down in 5 minutes if not paired to conserve battery.
The remote control will go into sleep mode in 10 minutes if not being used.
Hold down and press the remote button to power off and the LED indicator will flash 3 times.

USING THE BUILT-IN
RECHARGEABLE LIGHT

Connect the included Micro USB cable for 1 hour to charge the internal battery on the light.
To turn the light ON or OFF hold down the power button on the side of the light for approx 3 seconds.

The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc., and any use of such marks by CJ Global is used under license. Other trademarks and trade names are those of their respective owners.

FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
is distributed by CJ Global Inc. All rights reserved. 2010 Maple Ave Fair Lawn NJ 07410
MADE IN CHINA