attenti 24074AVL GPS Tracking System User Guide
- June 6, 2024
- attenti
Table of Contents
attenti 24074AVL GPS Tracking System
Attenti Two-Piece Real-Time Communication (RTC) User Guide
Copyright ©2019 Attenti. All rights reserved.
No part of this publication may be reproduced, stored in a retrieval system,
or transmitted, in any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without the prior written permission of
Attenti.
The information in this document is subject to change without notice. The
software mentioned in this document is furnished under license and may only be
used or copied in accordance with the terms of such license. Contact software
manufacturers directly for terms of software licenses for any software
mentioned in this document not originating from Attenti.
All brand or product names are the trademarks or registered trademarks of
their respective holders.
Accessing the Offender Menu
To access the Offender Menu, use the Acknowledge (center) button.
Messages: Displays messages sent to the device.
Vibrate/Beep : Changes 2 Piece (RTC) alert mode.
ID Numbers: Displays ID numbers of assigned hardware. Alarm Set: Accesses
alarm clock function.
Call List: Displays the officer-defined phone numbers that the 2 Piece
(RTC) can dial.
Icon Glossary: Displays the icons that will appear with each alarm.
RF Exposure Statement
Attention Offender tracking device, Model 24014VL, has been evaluated under
FCC Bulletin OET 65C and found to be compliant with FCC RF radiation exposure
limits set forth for an uncontrolled environment. This device is to be used
solely by law enforcement agencies for tracking purposes.
The antenna(s) used for this transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter except in accordance with
FCC multi-transmitter product procedures.
The use of accessories not approved by Attenti, including but not limited to
batteries,
antennas, wall adapters, chargers and belt clips may cause the device to
malfunction or in the case of unapproved electrical accessories may lead to
hazardous conditions, cause the device to exceed RF energy exposure
guidelines, and/or damage the device.
FCC Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
Canada Note: CAN ICES-3 B/NMB-3 B
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: Modifications to this device shall not be made without the written consent of Attenti. Unauthorized modifications may void the authority granted under Federal Communication Rules and Industry Canada Rules permitting the operation of this device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>