ACCO BRANDS M01520-D Wireless Dongle User Manual
- June 6, 2024
- ACCO BRANDS
Table of Contents
User Manual
Model number: M01520-M. M01520-D
1.1 Battery Installation
⑴. Open the battery cover on bottom of mouse, and pull out the Nano receiver.
⑵. Put battery in according to the polarity of the battery, then close the
cover.
2.2 Device connection:
⑴. Put Nano receiver into the computer’s USB port, and ensure good contact。
⑵. Computer will recognize a USB mouse device. (Can be seen from the device
manager)
⑶. Turn ON/OFF button (on the bottom of mouse) to “ON” for power on (“OFF”
button for power off); there red right on bottom that enter the working state.
⑷. Moving the mouse, you can enjoy wireless freedom.
⑸. If the connection failed，connection methods as follows：
Turn ON/OFF button to ON, and re-install battery, then reply Nano receiver;
Mouse can be work normally.
3.3. Sleeping mode:
Press any button to wake-up from Sleeping mode
4.4. receiver collection function:
⑴.For convenient to carry, can put Nano receiver into the collection tank of
mouse.
5.5 Environment condition:
⑴.Operation temperature:0 ℃～50 ℃，humidity:20％RH～90％RH without condensations.
6.6 Matters needing attention:
⑴.Applications of the mouse will be affected on the rough or reflection
surface.
⑵.Don’t disassemble mouse and receiver
⑶.Use dry and soft cotton product clean mouse.
⑷.Careful choice battery. its quality affects operation time and mouse life.
Instructions on “wireless”
Transmission frequency is 2.4GHz, it meets RED 2014/53/EU noun in Europe and
its radiation does not harm human body. (Far less than the mobile phone’s
radiation)
Instructions on battery
Don’t throw the waste battery into recycle bin while replace battery.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation
IC WARNING
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to
radio or television reception, which can be determined by turning the device
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the device and receiver.
–Connect the device into an outlet on a circuit different from that to which
the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>