TurboClean DualPro Pet/PowerForce PowerBrush Pet XL After Cleaning Care | Support

To maintain your machine between uses, follow the steps below:

• Turn off and unplug machine

• Pull Dirty Water Tank up and away to remove

• Open rubber tab on top of dirty water tank, pour out dirty water

  • Close rubber tab by pressing firmly in the middle

• Remove float stack from dirty water tank unscrewing the ring at the bottom of the tank

• Rinse the float stack under water to remove any debris

  • Ensure that float stack can freely move up and down

• Let float stack & dirty water tank dry

  • Do not put dirty water tank or float in dishwasher to clean

• Put float stack back into dirty water tank aligning the arrow on the float with the notch on the tank

  • Twist ring into place to secure float

• Remove debris from red filter below dirty water tank

• Remove Nozzle

  • Lift up behind Accessory Hose Door

• Rinse nozzle and wipe debris from machine

  • Use Nozzle Clean Out Tool to clean out pet hair or debris from the nozzle

• Use a cloth to wipe under nozzle and around brush roll

  • To remove and clean brush roll > Go to Brush Not Turning

• Let nozzle dry

• Return nozzle to machine

  • Line up the two hooks on nozzle to the bottom of the foot
  • Rotate the nozzle down and click into place
  • Secure the Accessory Hose Door in the down position

• Return dirty water tank to machine

  • Place the bottom in first then tilt it toward the machine and push it into place until it clicks

• Wrap cord around machine and store in a protected, dry area

• Recipient Email

Your Email

Your Name

Was this answer helpful?

Yes
No

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>