HIKVISION DS-PDHT-E-WB Wireless Heat Detector User Manual
- June 6, 2024
- Hikvision
Table of Contents
HIKVISION DS-PDHT-E-WB Wireless Heat Detector User Manual
English
1. APPEARANC
- Test/Silence Button
- Alarm/Test/Signal Indicator
- Tamper Switch
- Battery Holder
2. ENROLLMENT
3. INSTALLATION
I. Check signal strength
II. Install the detector.
4 TEST
User Manual
Scan the QR code for more information and operation help.
Specification
Warning
This is a class A product. In a domestic environment this product may cause
radio
inter-ference in which case the user may be required to take adequate
measures.
FCC Information
Please take attention that changes or modification not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
FCC compliance: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interierence in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interierence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
trvto correct the interference by one or more of the.
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver disconnected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment should be installed and operated with a minimum distance 20cm
between theradiator and your body.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>