Chicony Electronics TPC-C001RB Receiver board User Manual
- June 6, 2024
- Chicony Electronics
Table of Contents
Chicony Electronics TPC-C001RB Receiver board
Getting Started
Thank you for choosing this 2.4G Wireless Controller product. It operates with digital radio technology to ensure no hinder communication between your computer without connecting cable. The transmission and receiving of controller are free from angle restriction.
Package Content
- 1 x Remote Controller (RC-2053)
- 1 x Receiver Board (RG-2056) Product Specification
-
Frequency Range: 2403 MHz ~ 2480 MHz
-
Input Voltage / current:
Remote Controller (RC-2053) : 3Vdc. 2mA
Receiver Board(RG-2056) : 5Vdc ,50mA -
RC-2053 Battery State: Cut off detect voltage2.0V +/- 0.1V RG-2056 USB Input Voltage :4.4V~5.25V
-
Operation Distance: 10 meter at free space Preparing Controller and receiver
Note: The distance between the controller and PC system should not exceed 10 M.
Step 1: Insert batteries
The controller requires two NiMH AAA batteries.
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to instructions. Refer to”Important Battery
Information” for disposal instructions.
Step 2: Install
Receiver board is installed on the computer (AOI).
- Receiver board has 30pin connector, USB compatible with 30 pin connector.
- Receiver board connected to computer via 30pin Cable.
Cleaning the controller
- Use disinfectant wipes to clean the controller.
- Do not use any dissolvent, which may damage the surface of your controller.
FEDERAL COMMUNICATIONS COMMISSION (FCC) STATEMENT
This equipment has been tested and found to comply with the limits for a Class
B digital device, Pursuant to Part 15 the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference wil not occur in a particular installation. If
this equipment does cause harmful interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful Interference, and (2) This device must
accept any interference received, including interference that may cause
undesired operation.
WARNING:
You are cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void your authority to operate the
equipment.
CAUTION: AVOID PROLONGED USE OF THE KEYBOARD WITHOUT BREAKS. Take regular
breaks and keep a good posture. Consult your physician promptly if you notice
any lost of motion or pain in your wrist when using the keyboard.
IMPORTANT BATTERY INFORMATION
- Keep batteries out of reach of children.
- Insert the batteries in the proper direction as indicated by the positive (+) and negative (-) markings in the battery chamber.
- Do not mix old and new batteries or batteries of different types (for example, carbon and alkaline batteries).
- Always remove old, weak, or worn-out batteries promptly and recycle or proper disposal of them in accordance with Local and National Disposal Regulations.
- If a battery leaks, remove all batteries and recycle or dispose of them in accordance with the battery manufacture’s instructions and Local and National Disposal Regulations. Before inserting new batteries, thoroughly clean the compartment with a damp paper towel, or follow the battery manufacture’s recommendations for cleanup. If fluid from the battery comes into contact with skin or clothes, flush skin with water immediately
- Remove the batteries if your device is to be stored for an extended period of time without being used.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>