WINIX D480 Air Purifier User Manual

WINIX D480 Air Purifier

MODEL PART DIAGRAM

WHERE TO USE

Allow 12 ~ 18 in. of space between TVs, radios, and other electronics
Electromagnetic interference from certain electronics may cause product malfunction.
Place indoors away from direct sunlight
Direct exposure may cause product malfunction or failure. Only place on hard, flat surfaces Flimsy or slanted surfaces may result in abnormal noise and vibrations.
Allow at least 12 ~ 18 in. from walls for maximum air flow

CONTROL PANEL

1. Smart Sensor Detects the amount of odorous gas in the environment. When in Auto mode, the fan speed adjusts according to the detected amount of gas.
2. Filter Replacement Indicator LED light indicates when it is time to change the filter.
3. Filter Reset Button After replacing the True HEPA Filter, use a small object such as a paper clip, to press and hold the Filter Reset Button for at least 5 seconds until the Filter Replacement Indicator turns off.
4. Auto Mode Auto Mode automatically adjusts fan speeds according to your indoor air quality. The fan speed will adjust to low when air quality is good, medium when fair, and to high when poor
5. Auto Button Use the Auto Button to set the air purifier to Auto Mode.
6. Air Quality Indicator Color coded LED light indicates one of three levels of Air Quality: Red (poor), Amber (fair), and Blue (good
7. Fan Speeds Indicates the current fan speed.
8. Sleep Mode When Sleep Mode is activated, the Air Quality Indicator LED light is disabled an speed will automatically set to minimum speed (lower than ‘Low’) which will be nearly silent.When Sleep Mode is active, PlasmaWave® will be disabled, but it can be turned back on
9. Fan Speed Button Use the Fan Speed Button to set the desired Fan Speed. Fan Speeds cycle in this sequence: Low, Medium, High, Turbo, Sleep, Low.
10. Power Indicator LED light indicates when the air purifier is turned on.
11. Power Button Turns the unit on or off. During the first 30 seconds of powering up, the Air Quality Indicator will cycle through Blue, Amber and Red color Smart Sensor takes approximately 4 minutes to detect the air quality in the environment before normal
12. Light Sensor When in Auto Mode, the light sensor detects when to put the unit into Sleep Mode.

Detects the amount of ambient light in the environment.

STAGE AIR PURIFICATION

1. Pre-Filter
   Designed to catch larger airborne particles found indoors.

2. Activated Carbon Filter
   Reduces VOCs and household odors from cooking, pets, and smoke.

3. True HEPA Filter
   Captures 99.99% of airborne allergens including pollen, dust, smoke, pet dander, and other ultrafine particles as small as 0.003 microns. Based on independent laboratory tests conducted on inanimate particles as small as 0.003 microns.

INITIAL OPERATION

Remove the front panel by grasping its upper edge and gently pulling forward.

Remove the Pre-Filter, then the bag of filters behind it.

Remove the filters from the protective plastic bag

Install the filters until they fit securely in place.

• Pre-Filter (front)
• Activated Carbon Filter (middle)
• True HEPA Filter (back)

After filters are installed, close the front panel

Insert the power cord into an electrical outlet

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>