BLACKVUE B-124X Power Magic Ultra Battery User Manual

BLACKVUE B-124X Power Magic Ultra Battery

For the latest version of the manual and customer support go to www.blackvue.com

FCC Compliance Information

FCC Part 15.19 Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Part 15.105 Statement (Class B)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Part 15.21 Statement
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

MPE
The antenna(s) must be installed such that a minimum separation distance of at least 20 cm is maintained between the radiator (antenna) and all persons at all times. This device must not be co-located or operating in conjunction with any other antenna or transmitter.

BlackVue Power Magic Ultra Battery B-124X

The Power Magic Ultra Battery is designed to power your BlackVue dashcam in Parking Mode for extended periods of time without using your vehicle’s battery.

Safety instructions

Incorrect use of the Power Magic Ultra Battery can lead to poor performance and may cause overheating, ignition, explosion, etc. To use the product correctly please observe the following directions:

• Familiarize yourself with the contents of the user manual before using the product.
• Only use original BlackVue cables provided by the manufacturer. For replacements contact customer support or your nearest distributor.
• Only use the product to power a dashcam.
• Do not expose the product to direct sunlight or heat.
• Do not expose to high temperatures.
• Do not use a cigarette lighter multi-socket splitter (adapter) with the product.
• Do not put the product in a microwave oven or place it in a high-pressure environment.
• Do not repair or modify the product yourself.
• Do not throw the battery or subject it to any physical shock.
• Do not disassemble, compress or puncture the product.
• Do not use the product in an electrostatic environment as it can affect the operation of the battery protection circuitry.
• If the product emits an unusual odor during use, unplug it immediately and contact customer support or your nearest distributor.
• If the battery swells up, immediately discontinue using the product. Contact customer support or your nearest distributor.
• Keep the product away from children and pets.
• Do not allow metal objects to contact the terminals of the power and output cables.
• Ensure the battery does not come into contact with water or other liquids.
• Pittasoft Co., Ltd. is not liable for damage resulting from disassembling, opening or modifying the product.

Disposal of your battery pack

1. All electrical and electronic products should be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. Contact local authorities to learn about disposal and recycling options available in your area
2. Do not incinerate or expose to fire. Exposure to excess heat may result in fire or an explosion.

Componets

Check the box for each of the following items before installing the Power Magic Ultra Battery B-124X.

Note
The Power Magic Expansion Battery B-124E comes with a connector cable in place of the above cables/fuse tap kit.

At a glance

LED indicators and beeps

Beeping can be disabled over Bluetooth using the BlackVue Battery manager app.

Product features

• Charges while driving. Powers your dashcam while parked.
• Approximately 25 hours 35 mins of power from 40 minutes of charging (based on a dashcam that uses 3 W and a hardwired installation).
• Compatible with 2 installation methods:
  • DIY installation – standard cigarette lighter socket and plug (standard 5 A charging); or
  • Hardwired installation – standard cigarette lighter socket and hardwiring cable (rapid 9 A charging)
• Easily double usage time by plugging in an Expansion Battery (sold separately)
• Configure settings via Bluetooth using the companion smartphone app
• Compatible with both car (12 V) and heavy vehicle (24 V) electrical systems
• Battery protection circuitry for increased safety and extended battery life.
• Simultaneously charge your Ultra Battery and power your dashcam while driving.
• Power output automatically switches to draw power from the Ultra Battery when the engine is off.
• Battery cycle life: Rated for 1,500 full charge/recharge cycles before battery capacity falls under 80% of its original capacity.
• High temperature cut-off function shuts down the battery if the internal temperature reaches 80 °C (176 °F).
• When switched OFF the Ultra Battery retains its charge for more than 1 year.
• 1 USB port (5 V) allows you to simultaneously charge another device (smartphone, mobile Wi-Fi hotspot, etc.) while powering the dashcam

Installation guide

1. Set the power switch to the OFF position.
   

2. For DIY installation using a cigarette lighter plug power cable:

   • Plug the cigarette lighter plug power cable into the Ultra Battery’s DC in port. Plug the other end of the power cable into the vehicle’s cigarette lighter socket.
     

   • Set the power switch to the Cigarette position. Proceed to step 3.

Caution: When using a cigarette lighter plug power cable you must set the switch to Cigarette. If you set the switch to the Hardwire position when using a cigarette lighter plug power cable it may result in product failure, overheating, ignition, etc.

3. For a hardwired installation using a hardwiring power cable:

   • Plug the hardwiring power cable into the Ultra Battery’s DC in port.
     

   • Referring to your vehicle Owner’s Manual, identify a Switched (accessory power) fuse of 10A or less in your interior fuse panel. Typical examples are the cigarette lighter and car stereo fuse slots.
     Caution: If you connect the Ultra Battery to a Constant Power (BATT) fuse it may result in depletion of your vehicle’s battery.

   • Remove the identified Switched fuse and match its type with one of the 3 fuse taps.

   • Insert the ACC wire into the connector end of the fuse tap. Use a crimping tool or pliers to crimp the connector onto the wire.
     

   • Insert the fuse you removed from the fuse panel into the slot closest to the blades on the fuse tap.
     Note: If the original fuse is a low-profile mini type, use the new 10A mini type fuse instead (included).

   • Insert a new 20A fuse into the slot furthest away from the fuse tap blades.
     

   • Insert the fuse tap into the empty Switched fuse slot in the fuse panel.
     Caution: Refer to the diagram and insert the fuse tap in the correct orientation. In the correct orientation the new fuse (f.) gets power directly from the fuse slot without putting an additional load on the original fuse (e.). If you insert the fuse tap in the reversed orientation the additional load on the original fuse may cause it to blow.

   • Connect the ground wire (ring) to a ground point, such as a bolt, that is directly on a bare metal part of the vehicle’s frame. Secure the ground wire to the bare metal frame (for example by securing it under the bolt).

   • Set the power switch to the Hardwire position.
     

4. Plug the ‘Output cable’ into the port labeled Dashcam on the Ultra Battery.
   

5. Plug your dashcam’s power plug into the cigarette lighter socket on the Ultra Battery’s ‘Output cable’.
   Note: To ensure good electrical contact you can use electrical tape to tape the plug and socket together.

6. Use a pry tool to lift the edges of the windshield trim/molding and tuck in the power cord. Use the supplied Velcro strips to fix the Ultra Battery in place
   Caution: Do not expose the product to direct sunlight and/or heat.

BlackVue Battery Manager App

Download the BlackVue Battery manager app from the Google Play Store (Android) or the Apple App Store (iOS) to manage power and settings.

Connecting to the Ultra Battery via Bluetooth

1.  Turn on the Ultra Battery.
   • If you are using the cigarette lighter plug power cable set the power switch to the Cigarette position.
   • If you are using the hardwiring power cable set the power switch to the Hardwire position.
2.  Go to your smartphone’s Settings and turn on Bluetooth.
3.  Open the BlackVue Battery manager app. Select your Ultra Battery from the list. If your Ultra Battery is not shown tap Scan to refresh the list.
   • A sticker with the unique Bluetooth ID is attached to each Ultra Battery.

Battery information screen

Battery settings screen

Battery capacity

For each additional expansion battery we recommend incrementing by 6,600 mAh.

Power Magic Expansion Battery B-124E (sold separately)
Easily double usage time by plugging in a Power Magic Expansion Battery B-124E (6,600 mAh / 84.5 Wh). When the Ultra Battery and 1 Expansion Battery are fully charged they can supply power for approximately 53 hours 45 mins in total (based on a single dashcam that consumes 3 W). Charging time is approximately 2 hour 30 mins (Cigarette lighter plug) / 1 hour 20 mins (Hardwired).
When you add 1 or more expansion batteries please adjust the total available battery capacity using the BlackVue Battery manager app.
Multiple expansion batteries can be connected together in sequence to extend usage time even further. Please note charging time will also increase accordingly.

Product specifications

1.4 kg
Battery Cell Type| LiFePO4

Input Voltage / Current

| 12V system:

– Cigarette lighter plug: 12 V–17 V / 6.5 A (max)

– Hardwired: 12 V–17 V / 13.5 A (max)

24V system:

– Cigarette lighter plug: 23 V–30 V / 3.4 A (max)

– Hardwired: 23 V–30 V / 7.1 A (max)

Charging Voltage / Current| Cigarette lighter plug: 14.2 V / 5 A Hardwired: 14.2 V / 9 A
Charging Time| Cigarette lighter plug (standard 5 A charging): Approx. 80 mins Hardwired (rapid 9 A charging): Approx. 40 mins
Hours of Use| Approx. 25 hours 35 mins (based on a single dashcam that consumes 3 W)

Operating Temperature

| Charging Temperature: 0 °C − 45 °C (32 °F − 113 °F)
Discharging Temperature: -10 °C − 60 °C (14 °F − 140 °F)
Storage Temperature: -20 °C − 45 °C (-4 °F − 113 °F)
High Temperature Cut-Off| Approx. 80 °C (176 °F)
Capacity| 12.8 V / 6,000 mAh / 76.8 Wh

Output Voltage / Current

| Dashcam port: 11 V–14.2 V / 2 A (max)
USB port: 4.75 V–5.25 V / 2 A (max)

Customer Support
For customer support, manual and any updates please visit www.blackvue.com. You can also email a Customer Support expert at cs@pittasoft.com.

Limited Warranty

• The warranty period of this product is 1 year from the purchase data.
• If the product fails during normal and correct use within the warranty period, our service center will repair the product free of charge.
• Any disassembly, modification or alteration of the product will void the warranty.
• The cost to repair or fix any malfunction or problem caused by incorrect usage during the warranty period may be charged to the consumer.
• The manufacturer shall not be responsible or liable for any loss or damage caused by incorrectly using the product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>