BLACKVUE 461686 Conecta X OBD Power Cable Instruction Manual
- June 5, 2024
- BLACKVUE
Table of Contents
BLACKVUE 461686 Conecta X OBD Power Cable
INSTALLATION
- Turn off your vehicle’s ignition.
- Determine the location of your vehicle’s OBD port. it is normally in the shaded area above, alternatively check your owners manual.
- Connect the power plug to your BlackVue dash cam and carefully tuck the cable behind the trim before routing down to the ODB port location.
- Plug the OBD connector into your vehicle’s OBD port.
PLEASE NOTE: When first connecting Conecta X it will not immediately power the dash cam, please start the engine and leave connected for between 5 – 10 minutes to allow Conecta X to obtain an accurate voltage reading.
OPERATION
-
Accessory Mode
Switch to Accessory Mode if you do not require your dash cam to record while parked. The OBD Power & Parking Cable will automatically continue to provide power to your dash cam for 5 mins after the ignition is switched off. -
Parking Mode
Switch to Parking Mode and your dash cam will continue recording while your vehicle is parked, using car battery power. Should your vehicle’s battery power drop below 12V, Parking Mode will automatically disengage to prevent the battery discharging.
NOTE: Switch to Accessory Mode if you intend to leave your vehicle parked for more than 7 days.
CONTACT
- CONECTA LABS
- The Inox Building, Lanark, MLll 7SR
- support@conectalabs.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>