Wet Sounds ZERO6XZB ZERO Series 6 Inch Marine Speakers Owner’s Manual
- June 13, 2024
- wet sounds
Table of Contents
ZERO SERIES
High-Output Coaxial Speakers
Owner’s Manual
ZERO6XZB ZERO Series 6 Inch Marine Speakers
Congratulations!
Thank you for choosing this Wet Sounds™ product!
Wet Sounds is synonymous with live, loud, and clear audio solutions, built to
serve the needs of the marine and powersports enthusiast. The ZERO Series is a
first of its kind innovation for Wet Sounds, taking the legendary REV tower
speaker performance and re-imagining it for optimal use in more confined
spaces.
The high output in small, sealed enclosures means ZERO Series allows for ZERO
compromises. These speakers can also be used with or without a twist-lock
grille, making them ideal for both custom and OEM replacement applications.
The ZERO Series speakers and subwoofers utilize materials such as Nyla’s, a
composite of nylon and fiberglass, providing improved stability and superior
strength versus conventional speaker materials.
Please take a moment to read the instruction manual before starting your
installation. The guide will explain the benefits of the technologies
developed by Wet Sounds and will help you understand the correct installation
methods and use of this product. If you have any questions or concerns, please
contact a certified Wet Sounds dealer. You may also contact Wet Sounds
technical support by dialing 1-877-WET-SPKR (1-877938-7757).
Technology Specifications
ZERO 6 SPEAKER SPECIFICATIONS
RMS: 100W
Peak: 200W
Impedance: 4Ω
Frequency Response: 65Hz – 20kHz
Sensitivity: 90 dB at 1W/m
Mounting Depth: 2.72”
Hole Cut Out: 5.63”
Weight: 2.4 lbs (1.0 kg)| ZERO 8 SPEAKER SPECIFICATIONS
RMS: 150W
Peak: 300W
Impedance: 4Ω
Frequency Response: 55Hz to 20kHz
Sensitivity: 91.5 dB at 1W/m
Mounting Depth: 3.32”
Hole Cut Out: 7.36”
Weight: 3.4 lbs (1.5 kg)
---|---
|
Installation Specifications
-
We recommend checking if the mounting surface is flat with a square or level. Mounting to a curved surface will damage the product.
-
Tape the surrounding surface to prevent damaging the finish, and avoid cutting outside the cut line to prevent improper fitment.
-
For speaker alignment, the terminal indicates the bottom of the speaker, and the opposing lock tabs help for horizontal alignment.
Continued on the next page. -
Pre-drill the screw locations to prevent surface cracking.
-
Fasten the speaker with stainless steel 5/32” x 1.25” Phillips screws.
-
Place the grille on the speaker in a 45° angle.
-
Apply downward pressure on the grille and twist clockwise to lock.
-
Connect the speakers to the amplifier or source unit using spade connectors for each terminal.
Note: ZERO Series has a standard Deutsch connector compatible connection.
(PN: DT04-2P) PIN 1 (+) PIN 2 (-)
Technology Specifications
ZERO 57 SPEAKER SPECIFICATIONS
RMS: 100W
Peak: 200W
Impedance: 4Ω
Frequency Response: 65Hz – 20kHz
Sensitivity: 90 dB at 1W/m
Mounting Depth: 2.64”
Hole Cut Out: 6.37” x 4.97”
Weight: 2.3 lbs (1.0 kg)| ZERO 69 SPEAKER SPECIFICATIONS
RMS: 150W
Peak: 300W
Impedance: 4Ω
Frequency Response: 55Hz to 20kHz
Sensitivity: 91.5 dB at 1W/m
Mounting Depth: 3.32”
Hole Cut Out: 9.27” x 6.40”
Weight: 3.1 lbs (1.4 kg)
---|---
*Only the ZERO 69 comes with a grille. No grille is available for the ZERO 57.
Installation Specifications
- We recommend checking if the mounting surface is flat with a square or level. Mounting to a curved surface will damage the product.
- Tape the surrounding surface to prevent damaging the finish, and avoid cutting outside the cut line to prevent improper fitment.
- For speaker orientation, the mounting tabs indicate the top and bottom of the speaker.
- Pre-drill the screw locations to prevent surface cracking.
- ZERO 5×7: Fasten with stainless steel 5/32” x 1.25” Phillips screws
- ZERO 6×9: Place the XZ grille on the speaker. Fasten the speaker and grille using the stainless steel 5/32” x 1.25” Phillips screws.
- Connect the speakers to the amplifier or source unit using spade connectors for each terminal.
Note: ZERO Series has a standard Deutsch connector compatible connection.
(PN: DT04-2P) PIN 1 (+) PIN 2 (-)
Limited Warranty
What This Warranty Covers
This is a “Limited” warranty. This warranty covers any defects in materials
and workmanship and the warranty only applies to the original purchaser and is
not transferable. This warranty is only valid if the original purchase was
made from an authorized Wet Sounds dealer.
How Long Coverage Lasts
This warranty runs for 2 years from the date of the purchase.
What Is Not Covered
This warranty does not cover fading or discoloration caused by exposure to
sunlight or chemicals such as ammonia, household bleach, or any cleaning
material that contains abrasive substances. For information on how to prevent
fading or discoloration, consult
recommendations on cleaning products. Wet Sounds, Inc. does not cover the cost
for removal and reinstallation of any kind. Additionally, shipping to Wet
Sounds, Inc. is covered by the purchaser. This warranty is void and
inapplicable if Wet Sounds deems that the product was abused or misused;
including but not limited to Speaker product that has been improperly powered
(under or over powered), causing thermal (burnt voice coil) and/or mechanical
failure (torn surrounds or spiders), damage caused by accident, mishandling,
improper installation, negligence, normal wear and tear, excessive water or
heat damage, freight damage or products that have been altered in any way.
(The warranty is not transferable and will neither apply to products purchased
from unauthorized dealers nor product owned by anyone other than the original
purchaser from an authorized Wet Sounds dealer.) Wet Sounds is not responsible
for any damages to a consumer’s boat or person from a product failure. The
warranty is void if Wet Sounds deems the product was installed or used
improperly. Wet Sounds shall not be responsible for any incidental or
consequential damages, except to the extent provided (or prohibited) by
applicable law.
What Wet Sounds, Inc. Will Do
Wet Sounds, Inc will repair any part of your product that proves to be
defective in materials or workmanship. In the event repair is not possible,
Wet Sounds, Inc. will replace the product in question. If it is deemed
necessary, Wet Sounds, Inc. will either replace the entire product with a
refurbished unit or it will be replaced with a model that is similar in price
if that model is no longer available. Labor cost and materials needed to
complete this service will be at no charge to the purchaser. Additionally, the
cost of shipping to the consumer is also covered under this warranty.
How to Obtain Warranty Service
Contact Wet Sounds, Inc. either by phone at
877-938-7757 or by email at
warranty@wetsounds.com. A service representative
will assist you in the necessary actions to verify that the problem that you
are experiencing is covered under warranty. If it is in fact a
warranty issue, Wet Sounds will issue an RA number for tracking purposes and
give instructions on sending the product in for evaluation.
How State Law Applies
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
Internet Warning
Wet Sounds, Inc. products sold on any unauthorized website or internet auction
site are void of any and all manufacturer’s warranty. Please contact Wet
Sounds at 877-938-7757 or visit our
website at www.wetsounds.com to search for an
authorized site and/or an authorized retailer near you.
Caution & Respect
Wet Sounds speakers can achieve very high sound pressure levels. Please use
this product responsibly. Be aware that sound travels great distances across
water so please respect other boaters especially while loading/unloading at
the ramp or dock. Wet Sounds, Inc. is not responsible for any violations of
the law that may be a direct result of excessive volume. Please abide by the
rules but have fun doing it.
Wet Sounds, Inc.
www.wetsounds.com
877-938-7757
2975 Louise Street
Rosenberg, Texas 77471 USA
© 2023 Wet Sounds, Inc. All Rights Reserved. WET SOUNDS and associated logos
where
applicable are registered trademarks of Wet Sounds Corporation in the United
States and/or
other countries. All other trademarks are the property of their respective
owners.
ZERO SERIES