FLOS ARCHITECTURAL C1 Ceiling and Wall Spotlight Instruction Manual
- June 6, 2024
- FLOS ARCHITECTURAL
Table of Contents
FLOS ARCHITECTURAL C1 Ceiling and Wall Spotlight
ATTENTION
The safety of the device can only be guaranteed on condition that to be
respected the following instructions, both stages of installation and use
therefore it is highly recommended to keep them.
WARNING:
To carry out the installation, and whenever an operation in the device is
carried out make sure of having disconnected the electric power.
The device cannot be in any case modified or forced, any modification might
jeopardize the safety system making it dangerous. FLOS declines any
responsibility on modified products. The device has been designed for inside.
IP20 Ordinary.
Luminaire class Ill: Device with a very low tension of safety. The
conformity with the standard is only guaranteed if the device is powered by a
safety transfer according to the standard Cenelec EN 60472 or by equal safety
sources. Devices with a very low voltage of safety (BTS) marked, do not have
to be connected to drivers with earth socket.
Luminaires are intended for direct assembly on surfaces that are normally
flammable.
Under no circumstances should the luminaire be covered with insulating or
similar material. exclusively replaced by the manufacturer or his technical
service or a qualified 0 person in order to avoid any risk.
Use an appropriate equipment and in agreement with the standard. & The
luminaire should only be used with Fies accessories or components.
The symbol shown on the device indicates that the product must be eliminated
differently from the rest of the urban waste.
CLEANING INSTRUCTIONS
Use only a soft cloth to clean the appliance. For stubborn dirt, dampen the
cloth with water and clean only the reflectcr and the outer part of the
appliance. Do not clean or touch the LED/light source in any way. Warning: do
not use alcohol or other solvents.
The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar qualified person. Please refer
to the product label to check the electrical specifications
TECHNICAL DATA
MODEL
- C1 Ceiling Small I 500
- C1 Ceiling Large 1200
- C1 Wall Mono Small 500
- C1 Wall Mono Large 1200
- C1 Wall Double Small 500
- C1 Wall Double Large 12
CEILING NO TRIM
WALL NO TRIM
ED DOUBLE SPOT WALL SURFACE DOUBLE SPOT TILT AND LOCKING ADJUSTMENT
REGULATION
CEILING NO TRIM/ CEILING SURFACE LENS SHIFT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>