HIKVISION DS-PDC10DM-VG3 Wired Dual-Tech AM Curtain Detector User Manual
- June 6, 2024
- Hikvision
Table of Contents
DS-PDC10DM-VG3
Wired Dual-Tech AM Curtain Detector
User Manual
50131-2-4:2020
Security Grade3
Environment Class IV
**Certified by KIWA
**
Appearance
- Terminal
- LED Indicator
- Tamper Switch
- Mode Switch
- LED Jumper
- Anti-masking Jumper
- Direction Jumper
L→R: direction from left to right only
R→L: direction from right to left only
OFF: Turns off the direction selection
Installation
**C** Ceiling mounting
**W** Wall mounting
G Mounting with the general mounting plate.
L Mounting with L-mounting plate.
Resistor Wiring
Relay Status
| Normal| IntrusionAlarm| Fault| Mask
---|---|---|---|---
Alarm Relay| Close| Open| Close| Open
Fault Relay| Close| Close| Open| Open
Method 1: Use the jumper to select EOL (End of Line) resistance on
FAULT/TAMPER/ALARM pins.
Method 2: Add the resistor to FAULT/TAMPER/ALARM wiring ports.
Note: If EOL wiring is not used, leave the jumpers OFF. Do not force the
jumper if it is not matched the pin. Method 1 & 2 should not be used on the
ALARM/TAMPER at the same time.
a. Fault Resistance: 1K, 2K2, 6K8
b. Tamper Resistance: 1K, 2K2, 4K7, 5K6
c. Alarm Resistance: 1K, 2K2, 4K7, 5K6, 6K8
Connection Type
Note: The resistor must be connected in series with one end of the detector.
a. Normally Closed
b. Single End of Line Wiring
c. Double End of Line Wiring:
d. Triple End of Line Wiring:
Anti-Masking
Specification
| Detection Method | Passive Infrared, Microwave |
|---|---|
| Detection Range | Wall Mount: lam Ceiling Mount: 6m |
| Detection Angle | 5° |
| Detectable Speed | 0.2-3m/s |
| Sensitivity | Auto |
| White Light Filter | 6500Iux |
| Microwave Frequency | 24GHz(24.15-24.25GHz) |
| Digital Temperature Compensation | Support |
| Creep Zone Protection | Support |
| Anti-masking | Support |
| Digital Processing | Support |
| Sealed Optics | Support |
| Tamper Protection | Front, Rear |
| Alarm Output | Normally Closed |
| LED Indicator | Green(PIR), Red(Microwave),Green+Orange(Mask), Blue(Alarm) |
| Power Consumption | 22mA Max |
| Power Supply | 9 to 16 VDC |
| Typical Voltage | 12 VDC |
| Operation Temperature | -10 °C to 55 °C(14 °F to 131 °F) |
| Storage Temperature | -20 °C to 60°C(-4 °F to 140 °F) |
| Operation Humidity | 10% to 90% |
| IP Rate | IP65 |
| Dimension(WxHxD) | 29.2mm x 134.4mm x 39.5mm |
| Weight | 79g |
| Mounting Height | 2 to 4m |
| Mounting Method | Wall, Ceiling |
| Application Scenario | Indoor, Outdoor |
| Bracket | L-shaped adapter included |
Please use the power adapter compliant with LPS. The recommended power adapter is made by Shenzhen Honor Electronic Co., Ltd.
©2021 Hangzhou Hikvision Digital Technology Co., Ltd. All rights reserved.
About this Manual
The Manual includes instructions for using and managing the Product. Pictures,
charts, images, and all other information hereinafter are for description and
explanation only. The information contained in the Manual is subject to
change, without notice, due to firmware updates or other reasons. Please find
the latest version of this Manual at the Hikvisionwebsite
(https://www.hikvision.com/).
Please use this Manual with the guidance and assistance of professionals
trained in supporting the Product.
and other Hikvision trademarks and logos are the properties of Hikvision in
various jurisdictions. Other trademarks and logos mentioned are the properties
of their respective owners.
Disclaimer
TOTHE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS MANUAL AND THE PRODUCT
DESCRIBED, WITH ITS HARDWARE, SOFTWARE, AND FIRMWARE, ARE PROVIDED “AS IS” AND
“WITH ALL FAULTS AND ERRORS”. HIKVISION MAKES NO WARRANTIES, EXPRESSOR
IMPLIED, INCLUDING WITHOUT LIMITATION, MERCHANTABILITY, SATISFACTORY QUALITY,
OR FITNESS FOR A PARTICULAR PURPOSE. THE USE OFTHE PRODUCT BY YOU IS AT YOUR
OWN RISK. IN NO EVENT WILL HIKVISION BE LIABLE TO YOU FOR ANY SPECIAL,
CONSEQUENTIAL, INCIDENTAL, OR INDIRECT DAMAGES, INCLUDING, AMONG OTHERS,
DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA,
CORRUPTION OF SYSTEMS, OR LOSS OF DOCUMENTATION, WHETHER BASED ON BREACH OF
CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN
CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION HASBEEN ADVISED OF
THE POSSIBILITY OF SUCH DAMAGES OR LOSS.
YOU ACKNOWLEDGE THAT THE NATUREOFTHEINTERNET PROVIDES FOR INHERENT SECURITY
RISKS, AND HIKVISION SHALL NOT TAKE ANY RESPONSIBILITIES FOR ABNORMAL
OPERATION, PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER-ATTACK,
HACKER ATTACK, VIRUS INFECTION, OR OTHER INTERNET SECURITY RISKS; HOWEVER,
HIKVISION WILL PROVIDE TIMELY TECHNICAL SUPPORT IF REQUIRED. YOU AGREE TO USE
THIS PRODUCT IN COMPLIANCE WITH ALL APPLICABLE LAWS, AND YOU ARE SOLELY
RESPONSIBLE FOR ENSURING THAT YOUR USE CONFORMS TO THE APPLICABLE LAW.
ESPECIALLY, YOU ARE RESPONSIBLE, FOR USING THIS PRODUCT IN A MANNER THAT DOES
NOT INFRINGE ON THE RIGHTS OF THIRD PARTIES, INCLUDING WITHOUT LIMITATION,
RIGHTS OF PUBLICITY, INTELLECTUAL PROPERTY RIGHTS, OR DATA PROTECTION, AND
OTHER PRIVACY RIGHTS. YOU SHALL NOT USE THIS PRODUCT FOR ANY PROHIBITED END-
USES, INCLUDING THE DEVELOPMENT OR PRODUCTION OF WEAPONS OF MASS DESTRUCTION,
THE DEVELOPMENT PRODUCTION OF CHEMICAL OR BIOLOGICAL WEAPONS, ANY ACTIVITIES
IN THE CONTEXT RELATED TO ANY NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL-CYCLE,
OR IN SUPPORT OF HUMAN RIGHTS
ABUSES.
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE
LATTER PREVAILS.
This product and – if applicable – the supplied accessories too are marked
with”CE” and comply therefore with the applicable harmonized European
standards listed under the RE Directive 2014/53/EU, the EMC Directive
2014/30/EU, the RoHS Directive 2011/65/EU.
2012/19/EU (WEEE directive): Products marked with this symbol can not be
disposed of as unsorted municipal waste in the EuropeanUnion.For proper
recycling, return this product to your local supplier upon the purchase of
equivalent new equipment, or dispose of it at designated collection points.
For more information see: www.recyclethis.info
2006/66/EC (battery directive): This product contains a battery that cannot be
disposed of as unsorted municipal waste in the European Union. See the product
documentation for specific battery information. The battery is marked with
this symbol, which may include lettering to indicate cadmium (Cd), lead(Pb),
or mercury (Hg). For proper recycling, return the battery to your supplier or
to a designated collection point. For more information see:
www.recyclethis.info
CAUTION
- Install the equipment according to the instructions in this manual.
- This equipment is not suitable for use in locations where children are likely to be present.
- This equipment is suitable for use in gang boxes or another enclosure-protected device only.
- To prevent injury, this equipment must be securely attached to the floor/wall in accordance with the installation instructions.
- No naked flame sources, such as lighted candles, should be placed on the equipment.
- The equipment has been designed when required, modified for connection to an IT power distribution system.
- A readily accessible disconnect device shall be incorporated external to the equipment.
- The socket-outlet shall be installed near the equipment and shall be easily accessible.
- Burned fingers when handling the device. Wait one-half hour after switching off before handling the parts.
- Use only power supplies at the standard of 100 VAC to 240 VAC, 50/60 HZ.
- The equipment shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the equipment.
Ensure correct wiring of the terminals for connection to an AC mains supply.
Indicates hazardous life and the external wiring connected to the terminals
requires installation by an instructed person.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help. Refer to
FCC 15.105 section.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be co-located
or operating in conjunction with any other antenna or transmitter.
This device complies with FCC radiation exposure limits set forth for the
general population. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Legal and Regulatory Information
http://enpinfodata.hikvision.com/analysisQR/showQR/fb8ed4be
UD23719B-B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>