TOTALLEDS 5981 Magnetic Retrofit Kit Installation Guide
- June 4, 2024
- TotalLEDS
Table of Contents
TOTALLEDS 5981 Magnetic Retrofit Kit
Please read safety instructions before starting. Always have a qualified electrician install kits.
INSTALLATION
STEP 1
Turn off power and remove the lamps and ballast cover. Disconnect the
incoming power from the ballast, trim the tombstone wires, and remove the
ballast if desired or required by law.
STEP 2
Select your wattage on the driver DIP switch. See detailed instruction on back
of sheet on how to select and change your wattage. Default wattage is set as
per kit part number.
STEP 3
Place the RetroStrip magnetic driver into the fixture, and ground driver.
Where required, driver and boards should be permanently affixed to the fixture
with self-tapping screws provided.
STEP 4
Connect the new driver to the incoming power.
STEP 5
Apply the retrofit sticker
STEP 6
Select your color temperature on the magnetized switch on harness. See
color kelvin temperature suggestion chart in kit. Place magnetized switch into
the fixture.
STEP 7
Magnets are built-in for easy installation. Magnets holders also slide out.
To permanently adhere to the fixture, use self-tapping screws provided.
STEP 8
Place the magnetized LED boards into the fixture evenly and align with
existing lamp sockets/tombstones. Use self-tapping screws where required. LED
bars “Plug and Play” connection whips should face the same direction that the
driver harness is coming out of the ballast cover for connection.
STEP 9
Connect wire harness to the “Plug and Play” boards. Replace the ballast
cover and connect the wire harness so it is accessible through the end of
ballast cover.
856-444-0662 • howard@totalleds.com • www.totalleds.com
MAGNETIC RETROFIT KIT INSTALLATION
STEP 10
Turn on your power to test your newly retrofitted fixture.
STEP 11
Installation is complete. Enjoy
HOW TO USE THE DIP SWITCH
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>