valerie objects V9015014M Hanging Lamp Instruction Manual
- October 27, 2023
- valerie objects
Table of Contents
instruction manual
hanging lamp n°1
V9015014M (brass) / V9015014 B / C / U / Z
Instruction Manual
V9015014M Hanging Lamp
| protection class 1: the fitting must be earthed
---|---
| the maximum wattage indicated in each lighting unit, for example, must not
be exceeded
| for indoor use only, where direct contact with water is impossible
| this luminaire was designed to work only with the indicated voltage
| observe the indicated minimum distance between the lamp and the illuminated
materials/objects
| the armature can be used in combination with a dimmer. consult the sales
outlet for the correct type
| not to be disposed with domestic waste in rubbish bin, bring it to a staging
area for electrical waste
Safety directions
Please study the instruction manual carefully before installing or using this
product.
Keep this user manual for further reference / two persons needed for
installation.
- The luminaires may only be installed by authorized and qual ed technicians according valid regulations for electrical istallation.
- Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come into contact with any areas of the terminal connections or voltage control parts.
- Take account of the minimal separation distance from other objects and the room required around the fitting.
- If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
- When replacing a lamp, wait for it to cool, for a minimum of 5 minutes.
- Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components.
- Take account of all available technical information.
- If the external exible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufaturer or his service agent or a similar qual ed person in order to avoid a hazard.
1x hanging lamp (frame + power cord)| 2x set wall brackets + spacers (wall
plugs included)
---|---
| 
1x lamp shade| 1x Led bulb silvered cap 4W – 350lm
2700 K (dimmable) energy class A+
|
- assemble these two parts of the back part
- drill two holes with the requested diameter (ø 10 mm) for the appropriate wall plugs according your type of wall
- screw carefully the frontpart of the wall bracket on the back part (by hand) make sure the spacers are in between
- take care: do not screw the wall brackets tight, in order to turn the hanging lamp
