valerie objects V9018001 Ceiling Lamp Instruction Manual
- October 27, 2023
- valerie objects
Table of Contents
valerie objects V9018001 Ceiling Lamp
DIMENSION
protection class 1: the fitting must be earthed
the maximum wattage indicated in each lighting unit, for example, must not be exceeded
for indoor use only, where direct contact with water is impossible
this luminaire was designed to work only with the indicated voltage
observe the indicated minimum distance between the lamp and the illuminated materials/objects
the armature can be used in combination with a dimmer. consult the sales outlet for the correct type
not to be disposed with domestic waste in rubbish bin, bring it to a staging area for electrical waste
safety directions
Please study the instruction manual carefully before installing or using this product. Keep this user manual for further reference / two persons needed for installation.
- The luminaires may only be installed by authorized and qual ed technicians according valid regulations for electrical istallation.
- Maintenance of the luminaires is limited to their surfaces. During maintenance no moisture can come into contact with any areas of the terminal connections or voltage control parts.
- Take account of the minimal separation distance from other objects and the room required around the fitting.
- If in any doubt, consult a professional, taking local installation requirements into account. Some countries stipulate that lighting may be installed only by registered installers.
- When replacing a lamp, wait for it to cool, for a minimum of 5 minutes.
- Clean with a clean, dry cloth or brush, use no solvents or abrasives. Avoid dampness on all electrical components.
- Take account of all available technical information.
- If the external exible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufaturer or his service agent or a similar qual ed person in order to avoid a hazard.
1x ceiling lamp
(frame + power cord + ceiling pot)
2x set wall brackets + spacers
(wall plugs included)
1x lamp shade
1x Led bulb silvered cap 4W – 350lm
2700 K (dimmable) energy class A+
- assemble these two parts of the back part
- drill two holes with the requested diameter (ø 10 mm) for the appropriate wall plugs according your type of ceiling
- screw back part of wall bracket into (by hand) the wall plug
- screw carefully the frontpart of the wall bracket on the back part (by hand) make sure the spacers are in between
- take care:
- do not screw the wall brackets tight
- align careful the correct vertical hanging position
- tight both brackets
- installation of the ceiling pot
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>