sOmfy 1811612 Situo RTS Iron Transmitter Installation Guide
- June 6, 2024
- somfy
Table of Contents
sOmfy 1811612 Situo RTS Iron Transmitter
Introduction
Wall Mounting the Situo 5 Variation
Using the included Mounting Bracket:
- Peel the protective film from the adhesive on the back of the wall mounting bracket.
- Adhere the wall mounting bracket to a flat, clean,and dry surface (press firmly).
- Hang the Situo 5 Variation on the wall mounting bracket.
- Optional: Can also be screwed/anchored to wall.
Battery Replacement
- Slide to remove rear panel from remote control.
- Insert new CR2430 battery as specified.
- Replace rear panel on remote control.
Adding/Deleting a Situo 5 Variation RTS
To add or delete from a window covering: Using the control already associated with the window covering:
- Press and hold the PROG button (H) until the window covering briefly moves up and down.
On the Situo 5 Variation RTS to be added or deleted:
- Select the appropriate channel (G).
- Briefly press the PROG button (H), the window covering briefly moves up and down and the Situo 5 Variation RTS is added or deleted.
Programming a Replacement remote: Using the programming button on the drive head:
• Press and hold the drive head programming button until the motorized product
briefly moves up and down.
• Briefly press the PROG button (H) on the control to add or delete. Green LED
blinks 5 times.
You now have control over the window covering with a replacement remote
Operation
Channel Selector (G)
Before operating the Situo 5 Variation RTS, ensure the correct channel has been selected.
- Briefly press the channel selector button (G) to choose the correct channel.
- The selection indicator lights (F) correspond to channels 1 through 4.
- Channel 5 is selected when all indicator lights are on.
Arrow Buttons (B)
Depending on the type of window covering to be operated:
- Up/Open
- Down/Close
Stop button/“my” (C)
- Press the “my” button to stop the window covering action.
- If the window covering action has been stopped, press either UP or DOWN button on transmitter to activate in the desired direction OR press “my” button to activate motorized window covering to the pre-programmed “my” position.
Setting, modifying, or deleting the favorite preset position “my”. (C)
• Place the window covering in the desired position then pressand hold “my”
button for approximately 5 seconds to set thefavorite position.
• To delete the favorite preset position, place the window covering in the
established favorite position “my” and press and hold “my” button for
approximately 5 seconds.
How to Operate “my” Position. (C)
- The window covering will return to this position whenever you press “my” in the future.
- If the window covering is currently in motion, press the “my” button twice– once to stop it and once again to return it to the “my” position.
Tilt/Scroll Wheel (D)
- Used to adjust the slats on blinds and varying light and heat levels.
- Scrolling one notch at-a-time will open or close the slats accordingly.
Note : Visit https://store.somfysystems.com/ to purchase an additional or replacement product.
AS WITH ANY PRODUCT INVOLVING ELECTRICAL POWER, CAUTION MUST BE USED AT ALL TIMES. PLEASE CAREFULLY READ AND FOLLOW ALL OF THE INSTRUCTIONS.
This device is FCC certified and complies with part 15 of the FCC rules.RTS compatibility: RTS transmitters are capable of operating any RTS motor.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>