sOmfy 1870571 II RTS 1 Situo Transmitter Instructions

sOmfy 1870571 II RTS 1 Situo Transmitter

The Situo 1 RTS II remote control allows a group of one or more applications to be controlled. The Situo 5 RTS II remote control allows up to 5 groups of one or more applications to be controlled.

Safety and liability

Liability

These instructions must be kept by the user. Failure to follow these instructions or use of the product outside its field of application is forbidden and will invalidate the warranty and discharge Somfy of all liability.
This Somfy product must be installed by a professional drive and home automation installer. Moreover, the installer must comply with the standards and legislation currently in force in the country in which the product is being installed, and inform his customers of the operating and maintenance conditions for the product.

Never begin installing without first checking the compatibility of this product with the associated equipment and accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy representative or visit the website www.somfy.com.

Safety instructions

If used with a motor, you should also consult the instructions provided with the motor.
Do not use or install this product outdoors.
Do not knock or drop the product, expose it to flammable materials or sources of heat or moisture, or splash or immerse it.

Warning
This product contains a cell battery.
Do not swallow the battery: risk of potentially fatal chemical burns in less than 2 hours.
If the battery is inserted into a part of the body or if in any doubt, call a doctor immediately.
Keep batteries (new and used) and the product out of the reach of children. If the battery compartment no longer closes, do not use the product and keep out of the reach of children.
Risk of explosion, leaking flammable liquids or gases from the battery if it is kept at a high temperature (hot oven, fire), crushed, cut or subject to very low air pressure. Non-rechargeable batteries must not be recharged.

Situo 1 RTS II and Situo 5 RTS II in detail

(Figure A)

1. A Wall mount recess
2. B Up / On / Open / Tilt / Increase intensity button
3. C STOP/my button
4. D Down / Off / Close / Tilt / Reduce intensity button e e Button activation indicator light
5. E Button activation and group selection indicator lights g g Group selector switch
6. F PROG button
7. G Wall mounting.

Selection of groups on Situo 5 RTS II

(Figure B)

• Before performing any operation with the Situo 5 RTS II, check that the correct group has been selected.
• Short press on the group selector gg: visualisation of the group selected.
• Press several times: change the group selected.

The indicator light ff  for each group from 1 to 4 is lit individually then all the indicator lights are lit if group 5 is selected.

Installation

Adding/deleting Situo RTS II

͉ To program the first control: refer to the instructions for the RTS motor or receiver.
To add or delete the Situo  RTS II to/from an application: (Figure C)

1. On the individual control already associated with the application:
   • Press the PROG button (≈ 2 s) until the application moves up and down.
2. On the Situo RTS II to be added or removed:
   • For the Situo 5 RTS II, first select the group g
     Briefly press the PROG button: the application moves up and down and the Situo RTS II is added or deleted.

Fastening (Figure D)

CAUTION
This product must not be installed at a height greater than 2 m.

The building in which the product is used might reduce the radio range. Guaranteed “room range” (Situo 1 RTS II) / “floor range” (Situo 5 RTS II) use, depending on the environment. Never install the control point near or with a metal frame or on metal surfaces, as this can reduce the radio transmission range.

1. Remove the protective film from the adhesive on the back of the wall mounting.
2. Fasten the wall mounting to a flat, clean and dry surface. Press for optimum bonding.
3. Place the remote control on the holder.

Use

Before performing any operation with the Situo 5 RTS II, check that the correct group has been selected.

Buttons UP/DOWN

(Figure E)

Depending on the type of application to be controlled:

• Brief presses on up or down : up / on / open or down / off / close
• Long presses on up or down : tilt / increase intensity or tilt  / reduce intensity.

STOP button /MY

(Figure F)

• Briefly press MY to stop the application from being activated
• If the application has been stopped, briefly press MY to activate it until it reaches the favourite position (my).

Setting, modifying or deleting the favourite position (my) (Figure G)

• Place the application in the required position then press MY (≈ 5 s) to set the favourite position (my).
• Place the application in the favourite position (my) and press MY (≈ 5 s) to delete it.

Tips and recommendations

To replace the last control point lost or broken, contact a drive and home automation professional.

Replacing the battery

(Figure H)

CAUTION

• Read the section entitled Safety instructions.
• Risk of explosion if the battery is replaced by an incorrect type.

1. Step 2) Unscrew the rear cover of the remote control as shown in the diagram.
2. Push the used battery out of its housing using a plastic object.
3.  Insert a CR 2032 3 V battery, with the plus (+) side visible. Ensure your comply with the polarity. The power supply terminals must not be short-circuited. Push the battery fully into its housing.
4. Step 6) Screw the rear cover back into place.

DISPOSAL

Please separate storage cells and batteries from other types of waste and recycle them via your local collection facility.
We care about our environment. Do not dispose of the appliance with usual household waste. Give it to an approved collection point for recycling.

Technical data

• Frequency range and maximum power used: 433.050 MHz – 434.790 MHz e.r.p. <10 mW
• Radio range (line-of-sight, depending on the environment): Situo 1 RTS II: 50 m, Situo 5 RTS II: 150 m.
• Operating temperature: 0°C to +48°C
• Power supply: 1 type CR2032 battery, 3 V.

SOMFY ACTIVITES SA hereby declares that the radio equipment covered by these instructions is in compliance with the requirements of the Radio Directive 2014/53/EU and the other essential requirements of the applicable European directives. The full text of the EU Declaration of Conformity is available at www.somfy.com/ce.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>