CHOETECH T542-S Fast Wireless Car Charger User Manual

June 6, 2024
CHOETECH

CHOETECH T542-S Fast Wireless Car Charger User Manual

CHOETECH T542-S Fast Wireless Car Charger User Manual

Package Contents

1x Fast Wireless Charger Body; lx Suction Cup Mount OR 1x Air Vent Mount; lx USB Charging Cable; lx User Manual

Specifications

CHOETECH T542-S Fast Wireless Car Charger User Manual -
Specifications

Product Diagram

CHOETECH T542-S Fast Wireless Car Charger User Manual - Product
Diagram

Please check your package before use, if you get the suction cup mount, please follow option 1″ to install your devices; if you get air vent mount, please follow “Option 2” to install your devices

Installation of the Wireless Charger

Option 1 : Installation of Suction Cup Mount

CHOETECH T542-S Fast Wireless Car Charger User Manual -Installation of the
Wireless Charger

  1. Assemble the Mount: Remove the adjustment knob from the back of wireless charger and place over ball joint on suction cup mount → Connect the ball joint to the wireless charger and tighten the knob.

  2. Mount on the Flat Surface: Remove the plastic cover on suction cup → Clean the desired mounting surface → Move suction lever to the raised position → Place down the dock on flat surface and press down it firmly → Press the suction lever fully down to mount the dock on surface
    Note: To release the mount, lift up the lock lever and pull up the release tab.

  3. To Install and Remove the Phone: Put your phone on the car charger and slide down until your phone is secured
    Removal: Touch the quick-release button on any side and take your phone out.

  4. Telescopic Knob: Loosen it to extend the telescopic arm, and tighten to secure distance

  5. Pivot Knob: Turning allows you to pivot telescopic arm. Tighten to secure position.

Option 2: Installation of Air Vent Mount

CHOETECH T542-S Fast Wireless Car Charger User Manual - Installation of Air
Vent Mount

  1. Assemble the Mount: Remove the adjustment knob from the back of wireless charger and place over ball joint on air vent mount → Connect the ball joint to the wireless charger and tighten the knob.
  2. Mount on the Air Vent: Insert the air vent mount into the car air vent loner → Firstly turn the switch to direction I If too loose, turn to direction II
  3. To Install and Remove the Phone: Put your phone on the car charger and slide down until your phone is secured
    Removal: Touch the quick-release button on any side and take your phone out.

Attention:

  1. Do not close the car charger with magnetic stripe or chip card (ID card, bankcards, etc.) to avoid magnetic failure
  2. Please make sure that your device is Qi-enabled or installed with Qi receiver kit.
  3. A Quick Charge 3.0/2.0 power adapter {Not Included) is required for fast charging function
  4. Please use the USB cable attached
  5. Suggest removing the protective case during charging period
  6. This is a gravity car charger, and be careful about the hook behind when you take out the car charger from your car.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference,
(2)This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, Ashish can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna,
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
  • Consult the dealer or an experienced radio/ 1V technician for help.

For FAQs and More Information, Please Visit:CHOETECH T542-S Fast Wireless
Car Charger User Manual - QR Codehttp://www.choetech.com

www.choetech.com
support@choetech.com
b2b@choetech.com
http://www.facebook.com/choetechofficial
http://www.twitter.com/CHOETECH

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals