VIKING CJSZ16II Car Jumo Starter Zulu II16 16000 mAh User Manual
- June 6, 2024
- VIKING
Table of Contents
VIKING CJSZ16II Car Jumo Starter Zulu II16 16000 mAh
Thank you for choosing our air purifier VIKING. Please read the instrucon before the first use.
OVERVIEW
- USB output QC 9V / 2A, 5V / 2A
- charging input 1.5V / 2A
- Start output (blue) 12V
- LCD output
- ON / OFF button
- LED light
Using the Torch
- Slide the ON/OFF switch to ON. To turn the torch ON and OFF, Long press the light control switch for 3 seconds
- There are 3 models, normal. strobe and SOS. Pressing the switch buon lightly once the light is on will scroll through each mode. Notes: Please slide the ON/OFF switch to “OFF* if do not use it.
Contents:
- jump starter *1
- 3 in 1 mobile cable 1
- jumper cable *1
- user manual *1
Technical specificatons:
- USB-A: 1 x QC 9V / 2A, 1 x 5V / 2A
- USB output: 1 x QC 9V / 2A, 1 x 5V / 2A
- Startng current: 12V / 300A
- Peak output current: 12V / 600A
- Charging time: 5h
- Charging current: QC 9V / 2A, 5V / 2A
- Min. number of charges: 3000x
- Size: 175 85 43mm
- Working temperature: 0-60oC
Startng a car with the jump starter
- Connect the Jumper Cables to the Jump Starter by plugging the connector into the Jump Starter Socket. Make sure the blue plug is FIRMLY inserted into the jump starter.
- Connect the RED Battery Clamp to the Positive( + ) battery terminal and connect the BLACK Battery Clamp to the Negative(-) battery terminal. Make sure the battery clamps make good clean contact with the battery terminals.
- Slide the Jump Starter ON/OFF switch to the ON position.
- Start the car.
- Once the car has started, remove the jumper cables from the battery WITHIN 30 seconds (failure to do so much damages to the jump starter) and leave the engine running.
Warnings
- When using the Jump Starter make sure the blue plug is FIRMLY inserted into the Jump Starter. IF NOT, the jump starter will not start your car AND this may cause damage to the jump starter.
- Make sure the battery clamps make good clean contact with the battery terminals. IF the jump starter fails to start your car after 3 attempts,stop and check for other possible problems.
- Remove the clamps from the battery terminal within 30 seconds after starting your car. Failure to do so may damage the jump starter.
- DO NOT connect the two battery clamps together. Doing so is not only dangerous but will also damage the jump starter and void your warranty.
- Make sure the jump starter has over 80% power when used to start the car.
- Don’t let the product get wet
- Can’t put the product in water
- Do not use products under dangerous conditions
- Products should not be placed at temperatures exceeding 70 degrees Celsius.
- Products should not be exposed to heat sources.
- Only use the matching charger to charge.
- Under extreme conditions, leaks may occur in batteries. Use a cloth to wipe carefully. Avoid contact with skin. If contact with skin or eyes, use clear water immediately. Rinse and see a doctor in the hospital.
- After the end of battery life, the batery should be treated environmentally
What is Covered
This warranty covers any defects in materials or workmanship with the
exceptions stated below.
What is Not Covered
This warranty does not cover damage or product failure resulting from normal
wear and tear. physical abuse, improper use.
FAQ
-
Q: How many mes can the jump starter charge a mobile phone?
A: From a full charge the jump starter will charge a mobile phone about 4-5 times(tests done on an iPhone 6 1810mAh) -
Q: How long will the jump starter take to charge a mobile phone?
A: Approximately 2 hours depending on the phone. -
Q: How many times can the jump starter start a car from the FULL charge?
A: Approximately 15-20 times. -
Q: How long will the battery stay charged if left idle?
A:4-6 months. HOWEVER, we suggest recharging every 3months.
VIKING products are distributed and serviced by:
BONA SPES s.r.o.
Řepčín 250, Olomouc 77900, Czechia
VAT No.: 3476774
+420 777 109 009
www.best-power.cz, info@best-
power.cz
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>