ENCELIUM DALI Wired Manager Instructions
- June 3, 2024
- ENCELIUM
Table of Contents
**ENCELIUM DALI Wired Manager Instructions
**
OVERVIEW
The Encelium X Wired Manager — DALI provides individual control of lighting, allowing you to schedule, allocate, and manage light in a resource-efficient and practical way. The Wired Manager — DALI provides daylight-dependent and presence-dependent control of lighting, along with intelligent scheduling, task-related lighting, variable load distribution, real-time light control, analysis of energy consumption, and lamp failure indication. For more information on product specifications and design tools visit encelium.com.
PRODUCT SAFETY
READ THESE INSTRUCTIONS BEFORE USING THE PRODUCT
When using electrical equipment, basic safety precautions should always be followed, including the following:
Do not mount near gas or electric heaters or let power supply cords touch hot surfaces.
Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by unauthorized personnel.
The use of accessory equipment is not recommended by Encelium as it may cause an unsafe condition.
All DALI channels are internally connected together to the control unit. Make sure to consider this when installing.
Do not use this equipment for other than the intended use.
DIN RAIL MOUNTING
Tilt the Wired Manager — DALI onto the DIN Rail and push down until you hear a click.
REMOVING FROM DIN RAIL
nsert screwdriver into the tab and pull forward. Then pull up on the Wired Manager — DALI.
Tilt the Wired Manager — DALI to release it from the DIN Rail.
MAKE ELECTRICAL CONNECTIONS
The Wired Manager — DALI is powered from the 24V DALI Power Supply (sold separately). Connect the -/+24 V from the DALI Power Supply to the Wired Manager — DALI. Do not connect DALI lines to mains or any mains referred voltage. Properly cover the Wired Manager — DALI terminal connection areas, ensuring they are not accessible The Ethernet network installation must comply to relevant regulation and cables conform to minimum CAT5. The Wired Manager — DALI shall be installed in dry, indoor locations ONLY.
For instructions to install, configure, test, or use Encelium products or
systems, or to contact an Encelium Technical Support Specialist, please scan
the QR code or visit help.encelium.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>