sepura STP8X100 Tetra Hand Portables gateways and Intrinsicall Safe Radio Instructions
- June 6, 2024
- sepura
Table of Contents
- sepura STP8X100 Tetra Hand Portables gateways and Intrinsicall Safe Radio
- Safety
- Safely operating your radio
- Protection against hearing loss
- Operational conditions
- Batteries
- Accessories
- Safe installation into vehicles
- Servicing and Repairs
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
sepura STP8X100 Tetra Hand Portables gateways and Intrinsicall Safe Radio
Original Instructions: ENGLISH
Document Number: SPR-DOC-00170 Issue 17
Copyright
© Sepura Limited. 2002–2021
All rights reserved. This document is intended for the use of Sepura Limited’s
customers and/or other parties only for the purposes of the agreement or
arrangement under which this document is submitted, and no part of it may be
reproduced or transmitted in any form or means without the prior written
permission of Sepura Limited.
Disclaimer
Sepura’s policy is to continually improve its products. The statements made in
this document were correct at publication, but are subject to change without
notice.
Safety
THIS GUIDE CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ THIS GUIDE BEFORE USING THE PRODUCT.
Attention!
Sepura products are designed for use by mobile workforces, often working
alone, and are intended for use in occupational and controlled conditions.
It is the responsibility of the person operating the product to ensure that it
is operated safely at all times, and that local laws and regulations governing
the usage of
Radio Frequency (RF) wireless devices are observed. Obey all signs and
instructions relating to the usage to RF wireless devices.
It is recommended that you obtain training on how to safely operate this
product. Your personal safety could be affected if you do not understand how
to operate this product correctly.
This product must not be operated in environments that exceed those listed in
the product technical data sheet.
Exposure to RF energy
Sepura designs and manufactures products to meet strict guidelines and
international standards relating to Radio Frequency (RF) energy and the
potential health risks associated with using RF wireless devices. If you have
any concerns relating to long term health risks associated with using RF
wireless devices, you should obtain advice from your employer.
SAR (Specific Absorption Rate) is a measurement of how much electromagnetic
radiation is absorbed by the human body whilst using a mobile wireless device.
In Europe, the recommendations made by the International Commission on Non-
Ionising Radiation Protection (ICNIRP) have been adopted. All Sepura hand-held
products comply with these occupational limits.
Training should be provided by your employer on the correct usage of this
product to ensure the occupational/controlled exposure limits are met.
RF energy interference with electronic equipment
Some personal medical devices, such as hearing aids and pacemakers, can be
affected by RF energy. Obtain advice from your employer or the manufacturer of
your medical device before using RF wireless devices.
Some electronic devices are sensitive to RF energy. Always obey signs restricting the use of RF wireless devices. Sepura radios can operate in TRANSMIT INHIBIT mode, which restricts transmission, when working within health care facilities or other areas that are sensitive to RF energy.
Safely operating your radio
Always check the compliance ratings of your radio before operating it within potentially hazardous environments. Only intrinsically safe (ATEX/IECEx) radios can be operated within hazardous environments such as gas fumes, flammable chemicals or blasting areas.
Your radio should be used in its normal operating position when hand-held, worn on the body or secured within a cradle. When body-worn, your radio must be secured using a Sepura approved attachment. Ensure the antenna is at least 2.5 cm (1 in.) away from the body when transmitting.
Always ensure that your radio is in good operational condition and operating
correctly before entering any environment that has a potential risk to
personal safety.
NEVER fit or remove the antenna, battery, Smart/microSD card or an accessory
(including accessory covers on your radio) when operating in a potentially
hazardous environment.
Protection against hearing loss
NEVER place your portable radio or loudspeaker next to your ear, like a mobile phone, when making a PTT call. Your radio has a powerful loudspeaker that could potentially damage your hearing if held next to your ear.
Always check the volume level before making and receiving calls.
Listening to loudspeakers at high volumes may cause noise induced hearing
loss. The longer the exposure, the higher the risk.
Always use Sepura approved audio accessories with your radio. The use of non-
approved audio accessories may potentially cause loss of hearing.
Safety when driving a vehicle
Always obey local laws and regulations governing the operation of RF wireless
devices when driving a vehicle. Do not operate your radio if it creates a
distraction from driving safely and observing road conditions. Always POWER
OFF or set your radio to TRANSMIT INHIBIT mode at refuelling stations. Always
observe and obey warning signs relating to the use of RF wireless devices in
the vicinity of refuelling stations.
Operational conditions
- Do not exceed the operational conditions for your radio and battery.
- Prolonged exposure to extreme temperatures (over 55 °C or 131 °F), for example behind glass in direct sunlight, may cause damage to the product casing and the battery.
- Care should be taken to avoid mechanical impact.
- Important safety notes about the antenna
- NEVER touch the antenna when your radio is transmitting, this may cause a minor burn to the skin and may affect the operational range of the antenna.
- DO NOT handle, hold or swing your radio by its antenna, this may damage your radio and the antenna. NEVER use your radio if the antenna shows signs of damage.
- NEVER use your radio without an antenna attached, unless your radio is being used with an external antenna (such as an RSM antenna). Transmitting without an antenna may damage your radio.
- Only use Sepura approved antennas designed for use with this product.
Batteries
Only use Sepura approved batteries with this product. Sepura TETRA radios have
been tested and certified using Sepura approved batteries. The use of non-
approved batteries may damage the product, will result in the non-compliance
with regulatory requirements, compromise the product safety ratings, reduce
the length of operating time and will invalidate the product warranty.
Take care when handling and charging batteries. Accidental short-circuiting of
the battery electrical circuit (battery radios) by metal objects may cause
bodily injury such as a burn.
NEVER use a battery that shows signs of damage (not minor scratches) or has
been dropped or received a ‘sharp blow’. Damage to the battery may not always
be obvious.
Accessories
Only use Sepura approved accessories with this product. Sepura products have been tested to meet strict guidelines for personal safety and operational conditions. The use of non-approved accessories may damage the product, will result in the non-compliance with regulatory requirements, compromise the product safety ratings, and will invalidate the product warranty.
Always read the instructions supplied with the accessory for additional safety
instructions.
Connector covers on your radio must be fitted when an accessory is not in use.
A cover need not be fitted to the Facilities connector when your radio is
operating in Connector Protector mode (this feature may not be available on
your radio).
Safe installation into vehicles
Electronic control mechanisms within a vehicle can be affected by the use of RF energy such as ABS and transmission controls. Always refer to the vehicle manufacturer’s instructions and technical information relating to electronic modules and their wiring harnesses before installing an RF wireless device into a vehicle. Do not install the product within the air bag deployment area. In the event of the air bag inflating, your radio could be propelled at great force potentially causing serious injury.
Servicing and Repairs
Do not attempt to dismantle this product.
Servicing and repairs to this product must be performed by trained service
technicians at Sepura approved service centres.
Unauthorised modifications could cause the product to become non-operational
and will invalidate the product safety ratings and product warranty.
It is the responsibility of the user to ensure that the radio is maintained in
good working condition.
Regulatory
Federal Communication Commission (FCC) Regulations
Sepura TETRA radios generate, use and radiate RF energy. Radios that comply with the limits for a Class A digital device, pursuant of part 15 of the FCC rules are identified by an FCC certification ID label (located under the battery). Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment (rule part 15.21). This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
US and Canada Markets
FCC radiation exposure statement
This radio is intended for use in occupational/controlled applications where
users have been made aware of the potential risks for exposure and can
exercise control over their exposure. This product is not authorised for
general population, consumer or similar use. This transmitter must not be co-
located or operated in conjunction with any other antenna or transmitter.
IC RSS warning
The term “IC:” before the certification/registration number only signifies that
the ISEDC technical specifications were met.
IC radiation exposure statement
This radio is intended for use in occupational/controlled applications where
users have been made aware of the potential risks for exposure and can
exercise control over their exposure. This product is not authorised for
general population, consumer or similar use. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
European Regulations
Sepura declares that its TETRA radio products are compliant with the essential requirements and other relevant provisions of the European Radio Equipment Directive 2014/53/EU on the harmonisation of the laws of the Member States relating to the making available on the market of radio equipment and repealing Directive 1999/5/EC. These products are also compliant with directive 2011/65/EU having been designed and manufactured to the RoHS requirements.
Simplified EU declaration of conformity
Sepura declares that the radio equipment types SC21, SC20 and STP9000 series
hand-portable radios and SRG3900 and SCG22 mobile radios are in compliance
with Directive 2014/53/EU. The full text of the EU declaration of conformity
is available at the following internet address:
www.sepura.com/support/compliance-documents.
Your radio operates in the following frequency bands at the maximum
transmitted radio-frequency (RF) power:
This radio equipment can operate over a larger frequency range than the
country regulations allow, and therefore restrictions for use of this product
apply. Further information is available at
www.efis.dk/, and
https://www.efis.dk/views2/national_frequency_table.jsp,
and with the relevant country’s regulatory authority through those links. The
equipment must be operated within the required licence requirements provided
by the country’s regulatory body.
Radio type
| tEtRA frequency band (MHz)|
tEtRA nominal Output power (W)
| Bluetooth frequency band (MHz)| Bluetooth max. nominal
power (dBm) (EIRP)| GPs Frequency band (MHz)| Wi-
Fi frequency band (MHz)| Wi-Fi max. nominal power (dBm)
(EIRP)
---|---|---|---|---|---|---|---
StP9x38| 380-430| 1.8 @ 7.4VDC, 1.5a| 2402-2480| 4| 1559-1610| N/a| N/a
StP9x40| 407-473| 1.8 @ 7.4VDC, 1.5a| 2402-2480| 4| 1559-1610| N/a| N/a
SC2020| 380-430| 2.7 @ 7.4VDC, 2a| 2402-2480| 10| 1559-1610| 2402-2480| 17
SC2024| 403-470| 2.7 @ 7.4VDC, 2a| 2402-2480| 10| 1559-1610| 2402-2480| 17
SC2120| 380-430| 2.7 @ 7.4VDC, 2a| 2402-2480| 9| 1559-1610| 2402-2480| 17
SC2124| 403-470| 2.7 @ 7.4VDC, 2a| 2402-2480| 9| 1559-1610| 2402-2480| 17
StP8Xx38| 380-430| 1 @ 7.6VDC, 1a| 2402-2480| 4| 1559-1610| N/a| N/a
StP8Xx40| 407-473| 1 @ 7.6VDC, 1a| 2402-2480| 4| 1559-1610| N/a| N/a
SrG3900 tW| 380-430| 10 @13.2VDC, 3a| N/a| N/a| 1559-1610| N/a| N/a
SrG3900 UW| 407-473| 10 @13.2VDC, 3a| N/a| N/a| 1559-1610| N/a| N/a
SCG2229 tU| 380-470| 10 @13.2VDC, 3a| 2402-2480| 7| 1559-1610| 2402-2480| 15
*As the SCG2229 is provided with an antenna connector, Bluetooth and Wi-Fi nominal powers are conducted values, not EIRP.
FCC Supplier’s Declaration of Conformance 47 CFR § 2.1077 Compliance Information
Model | FCC ID |
---|---|
SC2024 | XX6SC2024 |
SC2024 | XX6SC2024W |
SC2028 | XX6SC2028 |
SC2028 | XX6SC2028W |
SC2124 | XX6SC2124 |
SC2124 | XX6SC2124W |
SC2128 | XX6SC2128 |
SC2128 | XX6SC2128W |
SCG2229 | XX6SCG2229 |
SCG2229 | XX6SCG2229W |
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party
PowerTrunk Inc.
66 York Street,
Jersey City,
NJ 07302
Email: sales@powertrunk.com
9000 Cambridge Research Park Beach Drive, Waterbeach Cambridge, CB25 9TL
United Kingdom
sepura.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>