REMAX RP-W26 Wireless Charger User Manual
- June 6, 2024
- REMAX
Table of Contents
RP-W26 Wireless Charger
User Manual
Product Appearance
Product Introduction
Xiaoxiao 15W Magnetic Wireless Charger has a generous and terse design. It’ s compatible with all Qi standard mobile phones and devices. With it, the charging equipment can plug and drop wirelessly, which is convenient and fast. It will provide you with unfettered life and let you enjoy free and safe wireless charging service.
Applicable Equipment
- The product has a built-in wireless charging device.
- The product has a reserved wireless charging interface, please install the receiver coil.
- Please install the device with a protective cover for receiving device. (Note: These receivers need to comply with the WPC Qi standard for compatibility.)
Items List
Wireless Charger
User Manual
Instructions
-
Connect the Type-c charging wire to the power adapter or plug it into the computer. (pictured below)
-
Place the equipment with a wireless charging receiver in the wireless charger to charge whenever you want.
Specifications
| Model | RP-W26 |
|---|---|
| Input | DC 5V/9V/12V=2A Max(Type-c) |
| Output | DC 5V= 1A, 9V=1A, 9V=1.66A(max) |
| Transmission Power | 15W |
| Transmission Distance | 2-8mm |
| Charge Efficiency | >86% |
| Size | 104’7.4mm |
Attention
- Keep the charger and receiver away from water or other liquids.
- Please make sure the power is disconnected, if you need to clean the charger.
- Please keep the using temperature between 0.45 degrees Celsius.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:0) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver,
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm of the
radiator of your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>