Skullcandy Jib True Series Wireless In-Ear Headphones User Guide

: June 6, 2024
: Skullcandy

USER GUIDE
Jib True Series

Auto Pair Mode ****

Pairing Mode

Auto Power – On ****

Power – On

Auto Power – Off ****

Power – Off

Charge Earbuds

Charge Case

Charge Case Battery Life

1 Flash = Low Battery 2 Flashes = Medium Battery 3 Flashes = High Battery

Check Battery Life

Pairing Mode ****

Left Side or Right Side
On Mode
Not Connected To Device

Pairing Mode

Left Side or Right Side
*Off Mode

Pairing Mode

Pair New Device

“Jib True”
Left Side or Right Side

Pair New Device

Power – On ****

Left Side and Right Side

Power – On

Power – Off ****

Play/Pause

Left Side or Right Side

Play/Pause

Track Forward

Right Side

Track Forward

TrackBack

Volume Up

Right Side

Volume Down

Left Side

Volume Down

Answer/End

Left Side or Right Side

Answer/End

Activate Voice Assistant

Left Side or Right Side

Activate Voice Assistant

Clear Pair Mode

Left Side or Right Side
*Off Mode

Reset Device

Questions Visit: www.skullcandy.com

Speaker Driver: 6mm, Impedance: 22 Ohms, THD <3%©1KHz, Voltage Regulation: 5V, 500mA, Bluetooth® 5.0, Frequency Band: 2402MHz — 2480MHz, Maximum Power: 9.7 dBm, Weight: 63.5g.
Skullcandy, , and other marks are registered trademarks of Skullcandy, Inc. All rights reserved.
Maximum operating temperature 45°C.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.

ISED Compliance Statement

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1 )This device may not cause interference. (2)This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Compliance Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End-user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value is reported under this standard during product certification for use when properly worn on the head.

Americas
Skullcandy, Inc.
6301 N Landmark Dr.
Park City, UT 84098 U.S.A.
Skullcandy.com| Canada
Skullcandy Canada ULC
329 Railway St. Unit 205
Vancouver, BC. V6A 1A4 Canada
Skullcandy.ca| Europe
Skullcandy Europe BV
Postbus 425
5500AK Veldhoven Nederland
Skullcandy.eu
---|---|---
Skullcandy UK LTD
Andrews House
College Road
Guildford
GU1 4QB
Skullcandy.co.uk| Mexico
Skullcandy Mexico S de RL de CV
Aristoteles 218
Polanco IV Seccion,
Miguel Hidalgo
11550, Mexico City, Mexico
Skullcandy.mx|

Contains a Li-ion battery. The battery must be recycled or disposed of properly.
Made in China.

R-C-Sku-S1JTW
R 018-210082

Jib Ture/Jib True 2
MODEL: S1JTW S1JTVVL
FCC ID: Y22-S1JTW
IC: 10486A-S1JTW
CMIIT ID:

CAUTION
Risk of explosion if the battery is replaced by an incorrect type; disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion; leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; a battery subjected to the extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

1 YEAR GLOBAL WARRANTY

1 Year Global Limited Warranty
The United States of America and Canada Product Purchases Only
Skullcandy products are backed by a 1-year limited warranty. If it doesn’t work the way we promised, we’ll make it light. For Guarantee Claims, Questions and Terms & Conditions visit www.skullcandy.com/warranty or call us at 1-888-MY SKULL

SIMPLIFIED EU
DECLARATION OF CONFORMITY
Hereby, Skullcandy Internation GmbH declares that the radio equipment type [Model: S2JTVV, S1 JTVV] is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: skullcandy.eu/product-documents