Baumer RR30 Radar Distance Measuring Sensor Instructions
- June 6, 2024
- Baumer
Table of Contents
RR30 Radar Distance Measuring Sensor
Instructions Manual
Dimensions
- All dimensions in mm
Connection diagram
BN = brown
BK = black
WH = white
BU = blue
GY = gray
Class 2, UL 1310, see FAQ
- Disconnect power before connecting the sensor.
Technical data
| sensing distance Sd | 0,5 … 60 m |
|---|---|
| temperature drift | < ± 10 mm |
| voltage supply range +Vs²) | 12 … 30 VDC |
| current consumption max. (no load) | 220 mA |
| output current | < 100mA |
| output circuit | current output/push-pull |
| short circuit protection | yes |
| reverse polarity protection | yes, Vs to GND |
| operating temperature | -40 … +65 °C |
| storage temperature | -40 … +85 °C |
| protection class | IP 68/69K & proTect+ |
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTICE: Changes or modifications made to this equipment not expressly
approved by Baumer may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Radiofrequency radiation exposure Information:
This equipment complies with FCC exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Canada Compliance Statement
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.