Skullcandy Indy Fuel Series True Wireless Earbuds User Guide

: June 6, 2024
: Skullcandy

Skullcandy Indy Fuel Series True Wireless Earbuds User Guide

DOWNLOAD THE SKULLCANDY APP

AUTO PAIR MODE

Pairing Mode

Auto Power – On

Auto Power – Off

Change Earbuds

Charge Case

Pairing Mode

Left Side or Right Side

Power Off

Play/Pause

Left Side or Right Side

Track Forward

Right Side

Volume Down

Left Side

Answer/End

Left Side Or Right Side

Activate Voice Assistance

Left Side Or Right Side

3 EQ Modes

Music, Movies, and Podcast

Ambient Mode

Find With Tile

Both Earbuds
Tile App Required
Find With Tile

Clear Paired Device

Both Earbuds
While On
Bluetooth Disconnected
Clear Paired Device

Re-Sync Earbuds

Both Earbuds
While On
Bluetooth Disconnected
Re-Sync Earbuds

Questions Visit: www.skulicandy.com

Contact Us

Americas
Skullcandy, Inc.
6301 N Landmark Dr.
Park City, UT 84098 U.S.A.
Skullcandy.com

Canada
Skullcandy Canada ULC
329 Railway St.
Unit 205 Vancouver, BC. V6A 1A4 Canada
Skullcandy.ca

Europe
Skullcandy Europe BV
Postbus 425
5500AK Veldhoven Nederland
Skullcandy.eu

Skullcandy UK LTD
Andrews House
College Road
Guildford GU1 4QB
Skullcandy.co.uk

Mexico
Skullcandy Mexico S de RL de CV
Aristoteles 218
Polanco IV Seccion, Miguel Hidalgo
11550, Mexico City, Mexico
Skullcandy.mx

Specifications

Speaker Driver: 6mm,
Impedance: 16 Ohms, THD <3%@1KHz,
Voltage Regulation: 5 V ,
Bluetooth® 5.2,
Frequency Band: 2402MHz — 2480MHz,
Maximum Power: < 8 mw,
Weight: 57g.

Maximum operating temperature 45°C.

Risk of explosion if the battery is replaced by an incorrect type disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion; leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

this device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

ISED Compliance Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

ISED SAR Compliance Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The portable device is designed to meet the requirements for exposure to radio waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue. The highest SAR value reported under this standard during product certification for use when properly worn on the head.

Contains Li-ion Battery. Battery must be recycled or disposed of property.

Hardware Version:
(Earbuds) V03 (Charge Case) V02

Software Version:
(Earbuds) FW132 (Charge Case) FW V006
Icons

R-C-Sku-S1IFW

Made in Vietnam

Warning: To Avoid hearing damage, do not listen at high volume levels.

1 YEAR GLOBAL WARRANTY

United States of America and Canada Product Purchases Only Skullcandy products are backed by a 1-year limited warranty. If it doesn’t work the way we promised, we’ll make it right. For Guarantee Claims, Questions and Terms & Conditions visit www.skullcandy.com/warranty or call us at 1-888-MYSKULL

SIMPLIFIED EU DECLARATION OF CONFORMITY

Hereby, Skullcandy Internation GmbH declares that the radio equipment type [Model: S2IFW] is in compliance with Directive 2014/53/EU.The full text of the EU declaration of conformity is available at the following internet address: skullcandy.eu/product-documents