BRAUN Series 8 8370cc Electric Shaver User Manual

BRAUN Series 8 8370cc Electric Shaver

WHAT’S IN THE BOX

INSTRUCTIONS

Read these instructions completely, they contain safety information. Keep them for future reference.

Important
Your appliance is provided with a power supply, which has an integrated trans- former (Safety Extra Low Voltage). Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock. Only use the power sup-ply provided with your appliance. If the appliance is marked 492 , you can use it with any Braun power supply 492-XXXX. This appliance is suitable for cleaning under running water and use in a bathtub or shower. For safety reasons, it can only be operated cordless. Detach the shaver from the power supply before using it with water. Do not open the appliance! The rechargeable batteries included can only be replaced by an authorized Braun Service centre.
Do not use if the appliance, the foil or the power supply are damaged. This appliance can be used by children aged from 8 years and above and per-sons with reduced physical, sensory or mental capabilities or lack of experi-ence and knowledge if they have been given supervision or instruction con-cerning the safe use of the appliance and understand the hazards involved. Children shall not play with the appli-ance. Cleaning and user maintenance shall not be made by children unless they are older than 8 years and super-vised.
Warning
Keep power supply, charging stand and Clean & Charge Station dry.

Clean &Charge Station
To prevent the cleaning fluid from leaking, ensure that the Clean & Charge Station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface. The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator. Do not refill the cartridge and use only original Braun refill cartridges.

Shaver

1. Foil & Cutter cassette
2. Cassette release button
3. Multi Head Lock switch
4. On / off button
5. Shaver display
6.  Travel lock
7.  Replacement indicator for Foil & Cutter cassette 5c Status segments
8.  Minutes left display
9.  Cleaning indicator
10.  Plug reminder
11.  Battery icon*
12. Precision trimmer
13. Shaver-to-station contacts
14. Release button for precision trimmer
15. Shaver power socket
16. Power supply
17. Travel case

Basic operating information

•  A full charge takes 1 hour and provides up to 60 minutes of cordless shaving time. This may vary depending on your beard growth and ambient temperature.
•  Recommended ambient temperature for charging is 5 °C to 35 °C, for storage and shaving it is 15 °C to 35 °C. The battery may not charge properly or at all under extremely low or high temperatures.
•  Do not expose the appliance to temperatures higher than 50 °C for extended periods of time.
•  When the shaver is connected to an electrical outlet, it may take some minutes until the display illuminates.

Charging

• Connect the shaver to an electrical outlet by plugging the power supply (10) into the power. socket (9) / the charging stand (10a), until it clicks into place. For cc models plug into the station power socket (see chapter «Clean & Charge Station»).
•  For first-time charge, charge continuously for at least 1 hour.
•  The actual charge status is shown on the display.

Display

•  The display information is dependent on the model.
•  Some models only show icons during charging or operation. On other models a series of icons is also shown after the shaver has been turned off.
• The table below shows the icons that can appear on the shaver display.

Battery status

Battery status

| __| The battery status is shown with segments and additionally in digits (for some models also with a battery icon).

• The status segments appear / disappear gradually with the status of the battery power.

• The digital number shows the remaining shaving time in

minutes.

| ____

|

__

Plug reminder

(low charge / cordless operation only)

_

| 1. Flashing: Battery is in low charge , i.e. 5 minutes shaving time are left.

2.  Fast flashing: This appliance can only be operated cordless. Disconnect the shaver from the power supply

before turning it on.

Travel lock
| When the travel lock icon appears on the display, the shaver is locked.
Replacement indicator for Foil & Cutter cassette

| The replacement indicator

shows the usage of the Foil & Cutter cassette. The

status segments disappear gradually with the numbers of

shaves*.

Cleaning indicator

(with Clean & Charge station usage only)

| The cleaning indicator lights up after each shave as

a reminder that the shaver should be cleaned in the

Clean & Charge Station.

Usage

Make sure that the shaver is disconnected from the power supply. Press the on / off button (4) to operate the shaver.

Tips for a perfect shave

1.  Position the shaver at the right angle (90°) to your skin.
2.  Stretch your skin slightly with your hand.
3.  Shave against the direction of your beard growth.

Multi Head Lock switch (head lock)
The shaver head can be locked in five positions to shave hard-to-reach areas (e.g. under the nose).

• Slide the Multi Head Lock switch (3) down to lock the shaver head.
• Move the shaver head manually to your desired position.
• For automatic cleaning in the Clean & Charge Station the head lock needs to be released.

Precision trimmer
The trimmer can be used to trim sideburns, mous-tache or beard Press the release button (8) and slide the trimmer (6) upwards.

Travel lock
The shaver can be locked to avoid unintended starting of the motor (e.g. for storing in a suitcase).

Foil replacement
To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when the foil replacement indicator lights up (and no status segments are visible)

•  To remove the Foil & Cutter cassette press the release button (2).
•  Press the on / off button for 8 seconds to reset the counter.
•  Afterwards you need to unlock the shaver (see chapter «Travel lock»).
•  On some shaver models the replacement indicator

Cleaning

Cleaning under running water Especially important after foam or gel usage

•  Switch on the shaver cordless and rinse the shaver head under hot running water until all residues have been removed. You may use liquid soap without abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.
•  Next, switch off the shaver, press the release button (2) to remove the Foil & Cutter cassette (1) and let it dry.

Cleaning with a brush
Switch off the shaver. Remove the Foil & Cutter cassette (1) and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. Do not clean the cassette with the brush as this may damage it!

Clean & Charge Station (C & C)*

cleaning, charging, lubricating and storing your Braun shaver.

1. Lift button for cartridge exchange
2. Station-to-shaver contacts
3. Clean & Charge Station display
4.  Level indicator
5. Status light
6. Cleaning program indicators
7. Start button
8. Cleaning cartridge

C & C Installation

• Remove the protection foil from the C & C display.
• Press the lift button (13) at the rear side of the C & C to lift the housing.
•  Hold the cleaning cartridge (17) down on a flat, stable surface (e.g. table).
•  Carefully remove the lid from the cartridge.
•  Slide the cartridge from the rear side into the base
•  Slowly close the housing by pushing it down until it locks.
•  Using the power supply (10), connect the station power socket (12) to an electrical outlet.

Removing the shaver from the C & C

Hold the C & C with one hand and tilt the shaver slightly to the front to release it.

Cleaning cartridge / replacement

When the level indicator (15a) lights up permanently red, the remaining fluid in the cartridge is sufficient for about 3 more cycles. When the level indicator blinks red, the cartridge needs to be replaced. After having pressed the lift button (13) to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping. Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution. The cleaning cartridge contains ethanol or isopro-panol (specification see cartridge), which once opened will naturally evaporate slowly. Therefore, each cartridge, if not used daily, should be replaced after approximately 8 weeks. The cleaning cartridge also contains lubricants for the shaving system, which may leave residual marks on the outer foil frame and the cleaning chamber of the C & C. These marks can be removed easily by wiping gently with a damp cloth and do not impact the shaver and its performance in any way.

Accessories

Braun recommends changing your shaver’s Foil & Cutter cassette every 18 months to maintain your shaver’s maximum performance. Available at your dealer or Braun Service Centres:

•  Foil & Cutter cassette: 83M
•  Cleaning Cartridge: CCR
•  Braun Shaver cleaner spray

Environmental notice

Product contains batteries and / or recyclable electric waste. For environment protection, do not dispose of in household waste, but for recycling take to electric waste collection points provided in your country. The cleaning cartridge can be disposed of with regu-lar household waste. Subject to change without notice.

Trouble-Shooting

Shaver
Shaver does not start when pressing the on / off button.| 1. The shaver can only be operated cordless.

2. Travel lock is activated.

| 1. Unplug the shaver.

2. Press the on / off button for 3 seconds to unlock the shaver.

Charging does not start when connected to power socket or put in the Clean & Charge Station.| 1. Sometimes charging starts delayed (e.g. after long storage).

2. Ambient temperature is out of valid range.

3. Power supply is not plugged into the shaver properly.

4. Shaver is not placed properly in

the Clean & Charge Station.

| 1. Wait a few minutes. Charging will start automatically.

2. Recommended ambient temperature for charging is 5 °C to 35 °C.

3. Power supply needs to snap in.

4. Contacts of the shaver need to align with contacts in the Clean & Charge Station.

Shaver does not charge completely and keeps blinking.| Ambient temperature is out of valid range.| Recommended ambient temperature for charging is 5 °C to 35 °C.
Unpleasant smell from the shaver head.| 1. Shaver head is cleaned with water.

2. Cleaning cartridge is in use for more than 8 weeks.

| 1. When cleaning the shaver head with water only use hot water and from time to time some liquid soap (without abrasive substances). Remove Foil & Cutter cassette to let it dry.

2. Change cleaning cartridge at least every

8 weeks.

Battery performance dropped significantly.| 1. Foil and cutter are worn which requires more power for each shave.

2. Shaver head is regularly cleaned

with water but not lubricated.

| 1. Renew Foil & Cutter cassette.

2. If the shaver is regularly cleaned with water, apply a drop of light machine oil on top of the foil once a week for lubrication.

Shaving performance dropped significantly.| 1. Foil and cutter are worn.

2. Shaving system is clogged.

| 1. Renew Foil & Cutter cassette.

2. Soak the Foil & Cutter cassette into hot water with a drop of dish liquid. Afterwards rinse it properly and tap it out. Once dry apply a drop of light machine oil on the foil.

Shaver head is damp.| 1. Drying time after automatic cleaning was too short.

2. Drain of the Clean & Charge

station is clogged.

| 1. Clean directly after shaving to allow enough time for drying.

2. Clean the drain with a wooden toothpick.

Clean & Charge Station
Cleaning does not start when pressing the start button.| 1. Shaver is not placed properly in the Clean & Charge Station.

2. Cleaning cartridge does not contain sufficient cleaning fluid (display blinks red).

3. Appliance is in stand-by mode.

| 1. Insert shaver into the Clean & Charge Station and push it to the rear side of the station (contacts of the shaver need to align with contacts in the station).

2. Insert new cleaning cartridge. Press the start button again.

3. Press the start button again.

Increased consumption of cleaning fluid.| Drain of the Clean & Charge station is clogged.| – Clean the drain with a wooden toothpick.

– Regularly wipe the tub clean.

Guarantee
We grant a 2-year guarantee on the product commencing on the date of purchase. Within the guarantee period we will eliminate any defects in the appliance resulting from faults in materials or work -man ship, free of charge either by repairing or re-placing the complete appliance at our discretion. Depending on availability replacement might result in a different color or an equivalent model. This guarantee extends to every country where this appliance is supplied by Braun or its appointed distributor.This guarantee does not cover: damage due to improper use, normal wear and tear (e.g. shaver foil or cutter block) as well as defects that have a negligible effect on the value or operation of the appliance. The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre (address information available online at www.service.braun.com).
For UK only:
This guarantee in no way affects your rights under statutory law.

References

• Braun Electric Shavers and Razors | Braun
• Braun Service

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>