Shenzhen Zhenghaixin Technology WA11 Wireless Charger for Watch and Earphone User Manual
- June 6, 2024
- Shenzhen Zhenghaixin Technology
Table of Contents
Shenzhen Zhenghaixin Technology WA11 Wireless Charger for Watch and
Earphone 
Product Diagram
Product Features
- lt can simultaneously charge the watch and earphone box;
- The headset charging area supports Qi protocol, the maximum output of the watch charging area is 2.5, and the headset box is the largest Output5W power;
- The green indicator light indicates the wireless charging status of the headset box charging zone
Packing List
- 2 in 1 wireless charger Cable xl
- Use Manual xl
Product specification
Product number: XDL-WAll Product name: 2 in 1 wireless charger (Apple version) Output: watch 2.5W (Apple Watch-6/SE); earphone box5W (Airpods 2/Pro) Input: DC5V2A Product size: 77.3’67.3’103.6mm Product net weight : 95g
Attention
- Beware of serious fall, abrasion or other, if there 1s any abnormal phenomenon, please stop immediately use;
- Don’t put the product in a humid environment, please keep it dry;
- Don’t use or store the product near heat sources (such as fire or heater)；
- Don’t connect the positive and negative poles 「eversely, disassemble or replace any accessories;
- Due to the large output power, the surface of the product will gradually become hot during charging, which is a normal reaction.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.