choetech B660 1OOOOmAh Wireless Charger Power Bank User Manual
- June 6, 2024
- CHOETECH
Table of Contents
User Manual
1OOOOmAh Wireless Charger Power Bank
Model: 8650
Package Content
1 x C110FACH Power Bank; 1 x US B Charging Cable; 1 x User Manual; 1 x Customer Service Card
Specifications
| Capacity | 10000mAIV3.7V/37wh |
|---|---|
| Input | MicroUSB:DC 5V-2.4A(MAX) USB-C: DC 5V-204A,9V-2A(MAX) |
| Output | UAB-C: DC5V=2.4A,9V=22A,12V=1.6A (MAX) |
USB-A: DC 5V=3A,9V=2A,12V=1.5A (MAX)
Wireless| 10W(MAX)
Instruction
- When urinating wireless charging feature, play ace ma he sure your device 6 is compatible with/ wireless charging. 0i-enabled or installed wIth Qi receiver kit when charging your phone wireless
- To act eve 20Wfast charging input. Power Dermot or Quidc Charlie fast charger is required.
- When charging two or rnotederdees at the same t ! ma the fast charging feature all aubitnaticelly change to standard charging.
- Please do not pass-thou* charge your devices. as itwill shorten product liftmen.
- If possible, please remove the protective case whir charging.
- Wireless charging func Ion words properly when power bank is switched on and status light is ‘son.
- Before initial use, please fully charge et the power bank to 100% battery.
- When connecting to the device please use original or certified cables onr% tt,
Attention
Internal battery poses a risk of fire and burns. Do not disassemble, crush, heat above 60 t/140 7, or incinerate. Follow manufacturer’s instructions.
Important Safety Instructions
When using this product, basic precautions should always be followed,
including the following:
a) Please read all instructions before using the product.
b) To reduce the risk of injury, dose supervision is necessary when the
product is used near children.
c)Please do not insert fingers or hands into the product
d) Please do nest expose the power bank to water (a. rain) or sold
temperatures (snow).
e) Ikingawall charger not recommended °rapid power bank manufacturer may posek
of fire or Injury.
f)Please do not use the power bank in sales of its output rating. Overload
outputs above rating nay resit in risk-off ireor injury b persons.
g) Do not use 1 he power bank if it is damaged or altered Damaged or altered
batteries may exhibit unpredictable behavior resulting in fire, explosion, or
risk: not injury.
h)It Please do not die: mite the rower bank. Reese seeks only evil: oozed
service preorders when sepia or rei mins required. incorrect reassembly may
Friuli in a risk of fire or injury to patrons.
i) Do not cross a power bank to ire or basin temperature. an eyesore to fire
or temperature above 100C (or 212 F) may cause eq: option.
J) To ensure product safet% Please have ProductservIced by a quaillleq repair
pen using original manufacturer’s replacement pans_
k)Please be surety switch off the power bank when not in use.
CM Connection E-Commerce (DE)GmbH Zum linnegraben 20, 65933, Frankfurt amMain,
Germany
infolgewecnnection.de Tel: 0049 06W27246648
Manufacturer: Shenzhen DAKTectinologyCo„ Ltd. Address: RSA 305, 3F, BLDG
No. 4, Demei Industrial CR Fulcang Community, Longhua St., Longhua District,
Shenzhen. China Contact info:
supporttelchnoelech.com
FCC Compliance Statement
Titles devIcecomolleswith Part 15 of the FCC Rules.00eratIon Issublecttothef
allowing two conditions: (1)111isdevise mayn atcatusehann full interference.
2) This device must accept any interference received, including interference
that may raze undesired Operation.
Warning: Changes or modifications note pretty approved by the party
responsible for eorrplien exiled void the line authority to operate ttieequi
want.
Note This equipment has been tested and found*, simply with the limits
ore ClassB digital crevice, pursuant to Part 15 o fits e FCC Rules. these
Iimilwredesgnedtoptwidereasonableprotecton against harmful interference in a
residential installation.
ThiseouiprneM generates, We, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
intro leer will not occur In a pail talar not stalkat on.
If this equipment does cause harmful interference to radio or television
reception, which dian be determined by turning the equipment off and on, the
user is encouraged to by to cam/ the Interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increasethitseparation between the equipment and receiver.
Connecttheequipmentin an outlet on an orcuildifterent front that toMichthe
receiver is connected.
• Corwin the dealer or an experienced rad& TVtechnidan for help.
Warranty
Garantie
24 Month Warranty
Lifetime Technical support
For FAQs and More Information, Please Visit:
| www.choetech.com
---|---
| support@choetech.com
| b2b@choetech.com
|
http://www.facebook.com/choetechofficaial
| http://www.twitter.com/CHOETECH
FCC Caution
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: -Reorient or relocate
the receiving antenna. -Increase the separation between the equipment and
receiver. -Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected. -Consult the dealer or an experienced
radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements.