MIRPLUS 24 Inch LED Round Bathroom Mirror Instruction Manual
- June 6, 2024
- MIRPLUS
Table of Contents
MIRPLUS 24 Inch LED Round Bathroom Mirror Instruction Manual
Please read carefully and save these instructions.
Don’t discard any of the packaging until you are sure that you have all of the
parts and the fittings.
Make sure power to the junction box is off before commencing installation.
**IMPORTANT**
- Unpack DO NOT lay mirror on tiled or concrete surface prior to installation. Mirror must be on protected surface to prevent chipping of the corners.
- Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may be concealed.
- A certified electrician must perform all The mirror must be connected to a GFI.
- The anti-fog mat operates only when the LED light is turn on by the touch
INSTALLATION
Please refer the installation diagram on the back of the page.
- Unpack the LED mirror and prepare tools ( See Pic.1 )
- Make sure the measurement on the carboard screw holes are matching up with steel hanger on the mirror back, then mark the screw holes according from the carboard with (See Pic.2)
- Drill holes, and put in the plastic plugs, then fix the steel hanger by screws and twisting the T shape nail to the wall.(See Pic.3&Pic.4);
- (Make sure the power off)Connect the cable before hanging the LED mirror to the wall. The way for connecting wires: Black wire to Live Terminal ( L ), White wire to Neutral Terminal ( N ), Green wire to Earth Terminal ( E ) (120V, 60Hz) OR connect as the instructions and Plug in to the ( See Pic. 5 )
- Hanging the LED mirror with steel hanger and lock it with the anti-pull iron sheet (See 5&Pic.6)
- Turn the light and anti-fog function by the dimmable sensor switch, see details as below:
Button:
1: Power control for LED Light and anti-fog, press the button (tip on it);
2: Long press for color temperature control, 3000K~6000K adjusting. It will
change gradually (3000k~6000k); level(warm yellow 3000K-warm white 4000K- cold
white 6000k)
MAINTENANCE
Wipe clean with a soft damp cloth. Apply glass cleaner to cloth and do not
apply directly to mirror.
Never use abrasive cleaners as these could damage the finish or exposed LED
strips.
INSTALLATION DIAGAM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>