MIRPLUS HDBM14A24 LED Backlit Mirrors Instruction Manual
- June 10, 2024
- MIRPLUS
Table of Contents
HDBM14A24 LED Backlit Mirrors
Instruction Manual
HDBM14A24 LED Backlit Mirrors
INSTALLATION INSTRUCTIONS
Apply to the below style of LED Backlit Mirrors Please read carefully and
save these instructions.
Don’t discard any of the packaging until you are sure that you have all of the
parts and the fittings.
Make sure power to the junction box is off before commencing installation.
IMPORTANT
-
Unpack mirror. DO NOT lay mirror on tiled or concrete surface prior to installation.
Mirror must be on protected surface to prevent chipping of the corners. -
Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may be concealed.
-
A certified electrician must perform all work. The mirror must be connected to a GFI.
-
The anti-fog mat operates only when the LED light is turn on by the touch sensor.
INSTALLATION
Please refer the installation diagram on the back of the page.
- Unpack the LED mirror and prepare tools needed. ( See Pic.1 )
- Make sure the measurement on the carboard screw holes are matching up with the steel base on the mirror back, then mark the screw holes according from the carboard with pencil. (See Pic.2)
- Drill holes, and put in the plastic plugs, then fix the hanging screws to the wall. (See Pic.3&Pic.4);
- Plug to the socket in the wall. (Make sure the power off)
- Hanging the LED mirror with the fixed screws on the wall. (See Pic.5)
- Turn the light and anti-fog function by the dimmable sensor switch, see details as below:
Button:
- Power control for LED Light and anti-fog, press the button (tip on it);
- Long press the button, the brightness will change gradually(5%~100%)
MAINTENANCE
Wipe clean with a soft damp cloth. Apply glass cleaner to cloth and do not
apply directly to mirror.
Never use abrasive cleaners as these could damage the finish or exposed LED
strips.
INSTALLATION DIAGRAM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>