OEM MIC-K17 Microphone User Guide
- June 6, 2024
- OEM
Table of Contents
User
Guide
About the Microphone
Standard Accessories
Instructions
How to Use
| On/Off | Left push to start, right push to shut down, blue light is on/off. |
|---|---|
| Bluetooth Connection | Turn on the mobile bluetooth, search for the bluetooth |
name ‘Mic-K17, then click it.
Play Music| Open music apps like Smule, select the songs you want to play, and
then the volume can be adjusted via the phone.
Mic Volume| Push the switch upward to + for maximum, and push to – for silent.
Echo Volume| Push the switch upward to + for the maximum echo reverberation,
and push to – to close the reverberation.
Magic Sound| Long press the Magi key for 3 seconds, and you can switch to 4
sound modes as you like.
Short press the button for last/next song and stop/play function.
How to Record
For audio cable| Plug the micro USB port into mic and 3.5mm audio port into
cellphone.
---|---
Open recording app like Apple Music, follow the using process, and start
recording.
PS: bluetooth will be automatically disconnected when plugging an audio cable.
Support
30 days No reason money back guarantee, 1 year warranty , and 24 hours
friendly customer service.
If you are disappointed and even angry Please don’t hesitate to contact us at:
support@rebatecamp.com
Specification
Microphone: Capacitance
Output power: 403W (Speaker Output)
Frequency Range: 100Hz 10KHz
Reverb Mode: Echo sound reverberation
Power Supply: Builtin LHion Battery
Battery Capacity: 1200mah
Charging Voltage: DC 5V
How to Charge
- Plug the micro usb port into mic, another port into a charger.
- Normally charge the mic in 3 hours. When finishing charge,the red light turns off.
- The mic works 5 hours in standard condition. (NOTE: The mic automatically turns off when its in a low power.)
FAQ
Status
| Reasons|
Solutions
---|---|---
No LED Light| Low power or charging cable not plugged in| Charging or check
the charging cable
Microphone not Working| Can’t be turned on or the vioce volume can’t be
adjusted| Long press power button or restart the mic
No Reverberation| Echo key not adjusted| Charge or restart the mic
Presence of Noise| Environmental noise mobile phone signal interference|
Adjust the distance between microphone and cellphone
When playing music, staccato appears| Distant bluetooh connection or
obstructions between phone and device.| Close to mobile phone or keep away
from obstructions.
---|---|---
Weak accompaniment sound| Low phone volume or bad-quality music.| Turn up
phone volume or download high-qualiy music.
Bluetooh can’t be paired| Distant bluetooh connection or already paired with
other phone.| Get closer to phone or disconnect with other phone.
Sound distortion when playing music| Volume too hight or battery power is too
low.| Lower Phone volume or charge device.
Phone can not use Bluetooth
Recording
| The mic does not react quickly| Restart the mic and change another phone to
pair them
Poor Recording| Phone does not match. Phone chip processing ability that is
weak| Restart the phone to try againor replace the phone
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>