ZKTECO FA50 USB Cable Installation Guide
- June 6, 2024
- ZKTECO
Table of Contents
ZKTECO FA50 USB Cable Installation Guide
Operation Instructions
-
The device has two USB plugs, as shown in the below Figure 1-1.
Insert the USB cable “A” of FA50M into the USB port situated on the host’s back, as shown in Figure 1-2. -
Right-click on My Computer > Properties > Device Manager. As shown in the figure below, if “Imaging devices” and “libusb-win32 USB Devices” appear, users can continue using the same device. But if “Imaging devices” and “libusb-win32 USB Devices” did not appear, it means that the device did not get connected appropriately.
Note: Generally, it is due to the insufficient power supply of the USB. Just insert the USB cable “B” into the USB port of the host.
Steps to Run Demo fo 2. r the First Time on Windows
Driver Installation
Double-click and open the “FA50 Demo” file, then click “FA50M InstallDriver”
to install the driver, as shown in Figure 2-1.
On the Installation window, click “Next”, as shown in Figure 2-2.
Then click “Finish” to successfully install the driver.
Demo Test Process
-
Double-click and open the “FA50 Demo” file, and then open the Demo Test software, as shown in Figure 3-1.
-
On the Demo Test software, firstly click “Open” to open the UVC camera. The camera gets opened successfully only if “Camera opened” gets displayed. Then the camera successfully captures the image and displays it, as shown in Figure 3-2.
Secondly, as shown in Figure 3-3, click “Open” to open HID, and “HID penned” will get displayed, which means the HID opened successfully.
-
Next, enter the registrant ID in the “User ID” field, then aim your face at the camera, and click “Add User” to register the user ID. And as shown in Figure 3-4, if “Add User successfully” appears, it means that the user ID is successfully registered.
Click “Enroll face” to register face, and if “Enroll face successfully” gets displayed, it means that face registration is successful.
As shown in Figure 3-6, the software displays the recognized registration ID’s username, and thus the recognition process is complete.
To clear the user, click the “Clear User” button, and if ” Clear User successfully” gets displayed, it means that the user removal is successful.
-
Precautions If the registration gets failed, click “Clear User” to clear the user and register again.
2. When clicking “Open” to open HID, and if “No device found” gets displayed, carry out the following solutions.
- Insufficient power supply, plug in two USB ports.
- The driver did not get installed successfully, repeat the steps of the driver installation process.
Technical Parameters
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>