PREMIUM LEVELLA PRF90DX Vertical Refrigerator Display User Manual
- June 6, 2024
- PREMIUM LEVELLA
Table of Contents
PREMIUM LEVELLA PRF90DX Vertical Refrigerator Display
OVERVIEW
Dear Consumers:
Thank you for purchasing our products very much. In order to ensure your
safety and achieve the best using effect, please read this instruction
carefully. It uses quality, effective and hermetic compressor with broad
ranges of the starting voltage suitable ambient temperature: not higher than
38 ℃. Reasonable marching of the showcase system guarantees its power full
refrigerant ability and energy saving.
Goods stored can be displayed clearly through the door made from luxurious
hollow glass.
The thermal insulating layer of the showcase made from hard polyurethane
foamed plastics makes it be light and good ability of cold-prevent.
Caution for safety
- Range of workable voltage: 98-133V. In order to avoid damaging the electrical performance of the compressor, please equip with a power regulated appliance, with the power not less than 500w, when the voltage is lower than 98V or higher then 133V.
- Individual single-phase socket must be used. It should be reliably connected to be a grounding wire. Caution: The grounding wire is not allowed to connect to a water pipe or a gas pipe.
- Strong base, strong acid, organic solvent and corrosive goods or those are easy to pollute to food are prohibited storing in the showcase, otherwise, it can cause corrosiveness or accident
- Don’t raise the showcase or the shell of the electric parts, or it will cause a decline in insulation and corrosiveness.
- When the showcase will be out of use for a long time, disconnect the power first, and then clean it. Please examine the circuit. Whether it is ok before reusing.
Caution for using
-
Unpack all packages before using the showcase don’t topple it over more then 60°while moving it.
-
The showcase should be installed in an environment of good ventilation. Cool and dry and without corrosive gas, it should not be installed close to heat sources or directly under the sunlight. The space more than 10cm,between the wall of the front and the back of the refrigerator should be allowed. When installing, the wheels should be padded well. So as to make the refrigerator be level and stable, or it will cause vibration and too much noise. between the wall of the front and the back of the refrigerator should be allowed. When installing, the wheels should be padded well. So as to make the refrigerator be level and stable, or it will cause vibration and too much noise
-
When initial operation, the refrigerator should run emptily about one hour before storing food in it
Temperature range inside the refrigerator is 32 Deg. F – 50 Deg. F, and the inside temperature could be adjusted by the thermostat, when you turn the knob in clockwise. The bigger the figure, the -
lower the temperature. Generally, the position or “3-4” is suitable. “0” position stands for stopping operation “6” position will be operating continually.
-
To save energy, the door should not be frequently opened or left open for a long time.
-
The surface and the inside of the refrigerator should be dry and clean. Long time moisture will cause the refrigerator rust slowly.(There will be some stains on the surface)
-
Periodical clean is suggested for your reference. Generally, 30-45 days once is best. When cleaning, it is best to wipe the inside and the surface of the refrigerator with the soft cloth ok in neutral soapsuds or detergent.
Caution: To ensure safety, the power plug must be pulled out before cleaning.
Documents / Resources
|
PREMIUM LEVELLA PRF90DX Vertical Refrigerator
Display
[pdf] User Manual
PRF90DX, PRF125DX, PRF155DX, Vertical Refrigerator Display
---|---