SPIN MASTER 66808RX2G4M Monster Jam Grave Digger Freestyle Force Monster Truck Instruction Manual
- June 5, 2024
- SPIN MASTER
Table of Contents
SPIN MASTER 66808RX2G4M Monster Jam Grave Digger Freestyle Force Monster
Truck
CONFIDENTIAL / UNAUTHORIZED USE PROHIBIT
Country of Origin – Placement
Factory according to production country to print Country of Origin (COO)
If corresponding country is not in below, contact Spin Master to provide
translation
China Made in China
Vietnam Made in Vietnam
India Made in India
Mexico Made in Mexico
- Spin Master Ltd. reserves the right to discontinue the MONSTERJAMRC.COM website at any time.
- Keep away from obstacles and electrical hazards.
CAUTION: Hair Entanglement. Tie back and cover hair and secure loose
clothing prior to play.
WARNING: CHOKING HAZARD – Small parts. Not suitable for children under
three years.
- This toy is only to be connected to equipment bearing either of the following symbols:
- Before first use: Read the user’s information together with your child.
- Retain this information, addresses and phone numbers for future reference.
- Do not change or modify anything on the toy.
Spin Master logo & © 2021 Spin Master Ltd. All rights reserved.
PARTS
- NOSE WHEELIE BUTTON
- TAIL WHEELIE BUTTON
- EGINNER MODE
- WHEEL ALIGNMENT BUTTONS
- ADVANCED MODE
- HARGING COMPARTMENT
- POWER SWITCH
- LED
INDOOR / OUTDOOR
CAUTION:
HAIR ENTANGLEMENT Tie back and cover hair and secure loose clothing prior to
play.
CONTENTS
-
1 Controller
-
1 Instruction Guide
HOW TO INSTALL BATTERIES
-
Press down on release button (A) to slide down battery cover (B).
-
Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
-
Replace battery door securely. Check your local laws and regulations for correct recycling and/or battery disposal.
HOW TO CHARGE
- Turn the vehicle off.
- Plug the small end of the charging cable into the charging port.
- Plug the charging cable into a 5V DC computer outlet.
- Blinking LED indicates battery is charging, solid ON for fully charged
HOW TO DRIVE
- Turn on the vehicle and place it on a flat surface.
- Hold the controller near your Grave Digger® Freestyle Force™, press the power button and wait until the power light stops flashing.
- You are ready to drive.
Use the remote control to drive.
NOTE : If your truck does not connect to the controller the first time, turn the truck off, take the batteries out of the controller and repeat STEP
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection again interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:
- Reorient or relocate the receiving antenna
- Increase the separation between the toy and the radio or the TV
- Consult the dealer or an experienced TV-radio technician for help.
NOTE:
Changes, adjustments or modifications to this unit, including but not limited
to, replacement of any transmitter component (crystal, semiconductor, etc.)
could result in a violation of FCC rules under part 15 and/or 95 and must be
expressly approved by Spin Master Ltd or they could void the user’s authority
to operate the equipment. Spin Master Inc., PMB #10053, 300 International
Drive, Suite 100, Williamsville, NY 14221. To contact the responsible party
please visit fcc.spinmaster.com Shielded cables must be used with this unit to
ensure compliance with the Class B FCC limits.
CANADIAN Class B statement:
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Spin Master International B.V. hereby declares that the radio equipment type
MONSTER JAM Grave Digger® Freestyle Force™ is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is available at
the following internet address: http://doc.spinmaster.com
Frequency band(s) : 2.414 – 2.465 GHz / Maximum radio-frequency power
transmitted: <10 dBm
CONTAINS 1 x 6.4V/700mAh Life BATTERY PACK AND REQUIRES 2 x 1.5V AAA (LR03) BATTERIES (not included). Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other household waste. The Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.
MODE SELECTOR
-
Move the skill switch to select either BEGINNER MODE or ADVANCED MODE
-
BEGINNER MODE : speed is limited while in nose or tail wheelie for smooth driving.
-
DVANCED MODE :**** speed is NOT limited while in nose or tail wheelie for stunt driving.
HOW TO STUNT
NOTE: FOR BEST STUNT PERFORMANCE MAKE SURE THE TIRES ARE CLEAN. If they are dirty, wipe the TIRES gently with a clean damp cloth. DO NOT SUBMERGE THE TOY IN WATER.
- Press the Nose Wheelie Button to balance on the front wheels and drive and stunt around
- Press the Nose Wheelie Button to balance on the front wheels and drive and stunt ar
- Press the Tail Wheelie Button to balance on the back wheels and drive and stunt around.
- Tap the Tail Wheelie Button to bounce the truck on the front wheels.
NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.
DIRECTIONAL CONTROL
HOW TO CORRECT WHEEL ALIGNMENT
Safety Precautions:
Keep hands, hair and loose clothing away from the motor / wheels when power
switch is turned ON. – Remove batteries when not in use. – Parental guidance
is recommended for the play. – Keep your toy in your sight so that you can
supervise it all the time. – New alkaline batteries are recommended to obtain
maximum performance. – Users should keep strict accordance with the
instruction manual while operating the product. Note: Parental guidance is
recommended when installing or replacing batteries. Under the environment with
electrostatic discharge, the toy may malfunction and require user to reset the
toy.
CARE AND MAINTENANCE:
Always remove batteries from the controller when it is not being used for a
long period of time. Wipe the toy gently with a clean damp cloth. Keep the toy
away from direct heat. Do not submerge the toy in water. This can damage the
electronic assemblies.
SPECIAL NOTE TO ADULTS:
Regularly examine for damage to the plug, enclosure and other parts. In the
event of any damage, the toy must not be used with the charger until the
damage has been repaired.
BATTERY SAFETY INFORMATION:
Batteries are small objects. Replacement of batteries must be done by adults.
Follow the polarity (+/-) diagram in the battery compartment. Promptly remove
dead batteries from the toy. Dispose of used batteries properly. Remove
batteries for prolonged storage. Only batteries of the same or equivalent type
as recommended are to be used. DO NOT incinerate used batteries. DO NOT
dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old
and new batteries or types of batteries (i.e. alkaline/standard/rechargeable).
Using rechargeable batteries is not recommended due to possible reduced
performance. Rechargeable batteries are only to be charged under adult
supervision. Replaceable-rechargeable batteries are to be removed from the toy
before being charged. DO NOT recharge non-rechargeable batteries. DO NOT
short-circuit the supply terminals.
SPECIAL LIFE BATTERY INSTRUCTIONS:
- Never charge battery unattended.
- Charge battery in an isolated area. Keep away from flammable materials.
- Do not expose to direct sunlight. There is a risk of the batteries exploding, overheating, or igniting.
- Do not disassemble, modify, heat, or short circuit the batteries.
- Do not place them in fires or leave them in hot places.
- Do not drop or subject to strong impacts.
- Do not allow the batteries to get wet.
- Only charge the batteries with the specified Spin Master™ battery charger.
- Only use the batteries in the device specified by Spin Master™.
- Carefully read the instruction guide and use the batteries correctly. – In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery.
- Batteries must be recycled or disposed of properly.
PRODUCT BATTERY REMOVAL INSTRUCTIONS:
Internal battery is factory installed and non-replaceable. Product disassembly
and battery removal must be performed by an adult. Do not puncture, cut, tear,
compress or deform product during disassembly. Ensure product is turned off,
then use a screw driver to remove all screws. Separate product body halves to
expose internal electronics. When battery is visible in its entirety use
scissors to cut a single battery wire, immediately wrap the cut wire end with
tape to isolate it, repeat until all battery wires are cut and isolated, and
the battery is free from the rest of the product. Dispose of battery in
accordance with your local battery recycling or disposal laws.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>