PROOX PRCDRX548BN 4 Inch Centerset 2 Handle Bathroom Faucet Instruction Manual
- June 12, 2024
- PROOX
Table of Contents
PROOX PRCDRX548BN 4 Inch Centerset 2 Handle Bathroom Faucet
Bathroom Faucet
The bathroom faucet is a stylish and functional accessory for your sink. It is available in various finishes, including MB (Matte Black), BN (Brushed Nickel), BG (Brushed Gold), CH (Chrome), and ORB (Oil Rubbed Bronze).
Installation Instructions
- Before You Begin: Measure the fixed width of the faucet, which is 3.94 inches. Also, measure the distance from the center of the first hole to the center of the second hole, which is 1.38 inches (35mm). Make sure the countertop thickness does not exceed the maximum limit.
- Handtighten: Attach the faucet to the sink by handtightening it. Do not use excessive force.
- Water Supply Line: Connect the water supply line to the faucet.
- Turn On Water Supply: Turn on the water supply and check for any leaks above and below the sink. Confirm Proper Installation: Open the faucet slowly and allow both hot and cold water to run for at least 15 seconds each to ensure proper functionality
Care Instructions
To maintain the quality and appearance of your bathroom faucet, follow these care instructions:
- Rinse the product with clear water after each use.
- Dry the product with a soft cloth to prevent water spots.
- Do Not: Use abrasive cleansers, cloths, or paper towels. Use any cleaning agents containing acid, polish, wax, alcohol, ammonia, bleach, solvent, or any other corrosive or harsh chemical cleansers.
Recommended Tools
- Plumber’s putty
- Thread seal tape (included)
CARE INSTRUCTIONS
Rinse the product with clear water. Dry the product with a soft cloth.
DO NOT:
Use abrasive cleansers, cloths, or paper towels. Use any cleaning agents
containing acid, polish, wax, alcohol, ammonia, bleach, solvent or any other
corrosive or harsh cheminalc cleansers.
RECOMMENDED TOOLS
PRODUCT DRAWING
INSTALLATION STEPS
BEFORE YOU BEGIN
HAND TIGHTEN
WATER SUPPLY LINE
TURN ON WATER SUPPLY
Check for leaks above and below the sink.
CONFIRM PROPER INSTALLATION
Open Slowly Allow hot & cold water to run for at least 15 seconds each.