moshi Orbito Bluetooth TX Audio Adapter Instructions
- June 6, 2024
- moshi
Table of Contents
Moshi Orbito Bluetooth TX Audio Adapter
Model name: Orbito, Bluetooth TX audio adapter
Brand Name: Moshi
Product designation: Orbito
Pairing
The adapter is paired to the closest Bluetooth device in paring mode. To pair
the adapter, start paring mode on a Bluetooth headphone or speaker, then
activate pairing mode on the flight adapter.
To do this, start with the adapter Power OFF and press and hold the power
button for 4 seconds. When pairing is started, 12 LEDs keep flashing, when you
find the device and start to connect, it will display an electronic
marquee.
Battery & Charging
The adapter holds 24 hours battery on a full charge. Connect the charger or
power bank to the USB-C port via the included USB-C
cable
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.